9
A
B
A.
Cable compartment lid
B.
"ON" LED light
1.OVERVIEW
2.Connections/buttons/led lights
USB CONNECTION
CONNECTION AT GE552Y058
Before connecting anything, switch the power o
ff
, complete the cabling, close the lid and
power the device on.
TROUBLESHOOTING
1) The device does not start:
2) The blue LED light does not stop
fl
ashing:
3) Not all the meters are revealed:
3.WALL FASTENING AND CABLE PASS
Temperature range:
Ingress Protection:
Protection Class:
Fastening:
Dimensions:
Power supply:
Consumption:
Radio Frequency:
W. M-Bus Mode:
Max distance between
two RPT:
7.TECHNICAL DATA
1
2
3
+55°C
-20°C
GE552Y053_QSG_2.4_en
Giacomini
reserves the right to make changes to this product without any notice
- in case of network power supply, check that the power is on
- in case you are using a USB port, check the USB cable quality and that the PC is enabled
to handle 500 mA of electrical power
- check that the meters that were not revealed are not too distant from GE552Y053 or that
the signal is not disturbed by thick concrete or metal walls
- check that the devices are on the list loaded in GE552Y053 or that the W. M-Bus devices
list receivable from GE552Y053 is not blocked
- warning: some W.M-Bus devices transmit periodically (within hours)
- check that the MESH network is not interrupted using GE552Y058 web interface or GE552Y056 sw
- Receiver and radio repeater for W. M-Bus devices (EN13757-4)
- Remarkable radio coverage due to multi-hop network
architecture (MESH)
- Manages up to 500 meters
- Last acquired data stored in a non-volatile memory
- Easy installation with software setup
- Simple and elegant design
- 100..240Vac power or via USB
- "Wall mounting" like installation
- USB interface for local data reading
- Optional WEB interface to match to GE552Y058
1
2
1 - Power input 100..240Vac (with clips)
2 - Multifunction button
3 - Multifunction button
4 - Reset button
5 - USB port
3 4
6 - MESH network TX-RX LED
7 - Wireless M-Bus network TX-RX LED
8 - Signal/reception level LED
9 - State LED
5
6 7
8
GE552Y053 repeater devices are provided with a MESH- ID=1 and channel 13, make sure that
all the repeaters and/or GE552Y058 have the same MESH network ID and radio channel
through GE552Y056
Operative: -20°C ... +55°C
Storage: -25°C ... +85°C
IP 40 (EN60529)
II
wall clipped
LxHxP 160x160x35mm
100..240Vac 50/60Hz
USB (5Vdc, 500mA) for commissioning
4.5W
868MHz - Max transmission power: 27dBm
S / T / C+T / S & C+T
- check that the device GE552Y058 is on and that the antenna is connected and in good position
(avoid placing it in switchboards or shielded environments)
- 1 blink "RAM memory error", 2 blinks "W.M-Bus radio module error",
3 blinks "MESH radio module error", 4 blinks "FLASH memory error", 5 blinks "Real Time Clock error"
- If turning o
ff
and restarting the GE552Y053, the error does not reset, the hardware
must be replaced.
- check that GE552Y053 is at least 5 metres distant from GE552Y058 and from other GE552Y053
- check that the ID and the MESH network channel are correct using GE552Y056 sw and are the
same ones used by GE552Y058
1 - upper hole
2 - lowe pre-hole
3 - cable pass pre-hole
4 - power supply connection
6. REPEATER NETWORK CONFIGURATION
1. Power on GE552Y058, connect to web interface and start antenna and device scan following
the user’s manual
2. Power on the
fi
rst device GE552Y053 to be installed and move it away to a minimum distance
of 5 metres from GE552Y058
3. Fixed blue GE552Y053 LED shows the connection to the MESH network
4. Once connected, it shows the MESH radio signal quality to the gateway, by turning on the green
front LED, 1 – insu
ffi
cient reception, 2 – su
ffi
cient, 3- good, 4 – excellent
5. Put GE552Y053 in a place where the reception signal is >=2 and of all the W. M-Bus
devices you expect to receive with this antenna is satisfactory
6. Check through GE552Y058 web interface or through GE552Y056 software and a PC connected to the
antenna by USB that W. M-Bus devices, that you want to receive, reach the GE552Y053
7. Fasten the GE552Y053 and proceed with powering a second repeater keeping at least 5 metres
away from both the GE552Y053 and GE552Y058
8. Once connected, it shows the MESH radio signal quality to the gateway, by turning on the front LED,
so proceed as for the
fi
rst GE552Y053
2 x Anchor 5x25
2 x Screws 5x30
2 x Glands
1 x GE552Y053
4.PACKAGE CONTENT
N
Power
supply
connection
GE552Y053 - QuickStart Guide
Wireless M-Bus 868 MHz REPEATER
DOWNLOAD DOCUMENTATION
: https://giacomini.com/en/products/ge552-w
2 x Screw 2,2x9,5
1 x clamp headband
USB
Mini USB
GE552Y058
MIN 5 m
MIN 5 m
MIN 5 m
a) The scanning phase is 12 hours. You can modify its duration through GE552Y058
b) You can have various independent GE552Y053 networks in the same building , in that case,
you need to have di
ff
erent ID or channel for each GE552Y056 group and the relative
GE552Y058.
You can modify these parameters through GE552Y056 software installed on a pc and connected via
USB to GE552Y053, see user’s manual for details.
c) In case the receiver receives more than 500 W. M-Bus devices or it receives devices belonging
to other plants, it might be necessary to make it selective. Therefore, you can load a list of W. M-Bus
devices marked by their serial number through GE552Y056 software.
In this way, the repeater will receive the data exclusively from the listed devices.
d) The USB / Mini USB cable is not included and is not present in the package
5.POSITIONING AND OPERATING DISTANCES
MAX 25 m
MAX 25 m
GE552Y058
GE552Y053
FLOOR 1
FLOOR 0
MAX 15 m
GE552Y053
FASTENING
WALL
WALL
CEILING
MIN
20 cm
MIN
20 cm
1) Fix the GE552Y053 repeater on fastening wall at a minimum
distance of 20 cm from the ceiling and from the adjacent wall.
2) The maximum operating distance between the devices
installed on the same
fl
oor is 25 meters, with no major
obstacles such as reinforced concrete or metal walls, columns
or beams or other metal structures.
3) The maximum operating distance between the devices
installed on di
ff
erent
fl
oors is 15 meters.
MIN 5 m
GE552Y053
MIN 5 m
GE552Y053
MAX 25 m
MAX 15 m
Manufactured by GIACOMINI SPA - Via per Alzo 39 - 28017 San Maurizio d'Opaglio (NO) - Italy
For details on the con
fi
guration of the GE552Y053 using the buttons, see the back of this
document, in the dedicated section.
L
max 2x1,5 mm
2
o 6 mm
4
