Specification Created 11/01
GE Appliances
JSS26BD—GE 30" Slide-In Electric Range
Dimensions (in inches)
23-3/16
30
30
If you are NOT using the
optional Filler or Backguard:
If you are using the
optional Filler or Backguard:
25
28-1/4*
36
Maintain
at least 6"
to side walls
Acceptable
Electrical
Outlet Area
45-1/8
2-1/4
5
6
4-1/2
30
30
30-3/4
30 Min.
15 Min.
6
*Wall to front of
closed door handle.
Optional Kits
(Available at additional cost)
JXS28—Rear Filler Strip Kit
JXS31—White Accessory Backguard
JXS32—Brushed-Chrome Accessory Backguard
JXS34—Black Accessory Backguard
JXS40—Endcap kit to accommodate replacement where
countertop may already be notched.
JXS52BB—Lower Trim Kit (Black)
JXS553WW—Lower Trim Kit (White)
JXS54AA—Lower Trim Kit (Almond)
Note:
All 30" Slide-In Ranges conform to U.L. requirements for 0" spacing
from range to adjacent walls below countertop. To reduce possibility of
scorching of the side wall adjacent to the heating elements, it is recommended
a minimum of 6" spacing from adjacent side walls be allowed for possible
extended, high-heat, no-load operation of heating elements.
Receptacle Location:
For all 30" Slide-In Ranges, locally approved flexible
service cord or conduit must be used because terminals are not accessible
after range installation. See shaded area in drawing for location of electrical
outlet box. Recommended outlet locations allow range to be installed directly
against rear wall.
Note:
Cabinets installed adjacent to slide-in ranges must have an adhesion
spec of at least 194°.
Installation Information:
Before installing, consult installation instructions
packed with product for current dimensional data.
KW Rating
240V
10.8
208V
8.1
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
For answers to your Monogram,
®
GE Profile
™
or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
