UX12B36PSS
12” High Backsplash
WARNING
To prevent ignition of combustible
materials, the entire back wall above the range
must be protected by a backsplash constructed of
non-combustible material.
This stainless steel backsplash accessory must be
installed in combination with a custom, non-combustible
backsplash built beyond the 12” height of the backsplash.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
■
IMPORTANT
—
Save these instructions
for local inspector’s use.
■
IMPORTANT
—
Observe all governing
codes and ordinances.
■
Note to Installer —
Be sure to leave these
instructions with the consumer.
■
Note to Consumer —
Keep these instructions with
your Owner’s Manual for future reference.
■
This kit provides for the installation of a 12” high
backsplash for 30”, 36” or 48” Professional Ranges
and Rangetops.
Installation
Instructions
31-10690-1 01-18 GEA
TOOLS AND MATERIALS REQUIRED
■ Gloves to protect against sharp edges
■ T-15 and #2 Phillips
screwdrivers
■ Drill with 3/32” and
9/64” bits
■ Safety glasses
■ Level
■ Pencil
This Kit Includes
■ Wall support panel
■ Cover panel
■ Hardware package with
– 5 Stainless Steel Torx 15
#8 self-tapping screws
– 5 Phillips #2 pan head wood
#10 screws
INSTALL 12” BACKSPLASH
WARNING
This backsplash must be securely
fastened to the wall. Failure to do so could result in
damage or personal injury.
■ Install and level the range or rangetop and the
range hood according to the installation instructions.
■ Remove the backsplash packaging and protective
film.
■ Use a level to pencil a horizontal line on the wall, 1/8”
above the range or rangetop. The 1/8” gap allows the
cover panel to overlap the wall support panel.
■ Locate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided).
■ Align the wall support panel on the marked
horizontal line and centered left to right.
■ The wall support panel must be secured to the wall
at all 4 corners. Use wood screws (provided) or wall
anchors (not provided) to secure the support panel
to the wall.
■ Place the cover panel over the wall support panel
and secure with Torx screws (provided). Install 2
screws on each side.
Wall Support Panel
Cover Panel
Hardware
Package
761Dia65
Install 4 Wood Screws
Install T-15
Screws
Wall
Support
Panel
Wall Support
Panel
Cover Panel
Center
Arrow
1/8”
