31-5000559 Rev. 0 10-20 GEA
Installation Instructions
for your new
RAB8116B, RAB8118B
RAB8120B, RAB8124B
Deep Wall Sleeves
Assembly Required
Wall Sleeve for All AZ Series
Zoneline Models
Before you begin - Read these instructions completely
and carefully. IMPORTANT – OBSERVE ALL
GOVERNING CODES AND ORDINANCES. Note to
Installer – Be sure to leave these instructions with the
Consumer. Note to Consumer – Keep these instructions
with your Owner’s Manual for future reference.
NOTES:
• Handle the sleeve carefully.
• The rear protective panel must retain in place until
the chassis or exterior grille is installed to assure
sleeve rigidity and squareness.
• If a sub-base is to be used, it may be desirable to
assemble it to the sleeve before securing the sleeve
in the wall.
CRITICAL DIMENSIONS
Ceiling
“A”
“B”
“C”
Roomside
Outside wall
“D”
)LQLVKHGÀRRURUWRSRIFDUSHW
NOTE: Care should be taken in location of electrical
supply entry in relationship to wall sleeve to ensure
access to power once the unit is installed.
Dimensions Recommended Installation Clearance
A
7RSRIVOHHYHWR¿QLVKHGFHLOLQJ´PLQ
B
3URMHFWLRQRIVOHHYHLQWRURRPIURP¿QLVKHG
ZDOOó´PLQQRVXEEDVHǪ´PLQZKHQ
VXEEDVHLVXVHG,IPRUHWKDQ´RIWKHVOHHYH
SURMHFWVLQWRWKHURRPDVXEEDVHRURWKHU
VXSSRUWLVUHFRPPHQGHG
C
3URMHFWLRQRIVOHHYHWRRXWVLGH´PLQ
D
+HLJKWDERYH¿QLVKHGÀRRURUWRSRIFDUSHW
´PLQZLWKRXWVXEEDVH´PLQ´PD[ZLWK
VXEEDVH
E
/HIW5LJKWVLGHRIVOHHYHWRDGMDFHQWZDOO
´PLQ
INSTALL Sleeve LEVEL IN ALL DIRECTIONS
SLEEVE LOCATION
6OHHYHPXVWEHORFDWHGRQDQRXWVLGHZDOOIRUSURSHU
RSHUDWLRQ$VDJHQHUDOUXOHWKHDLUFRQGLWLRQHUVKRXOG
EHFHQWUDOO\ORFDWHGLQDQRXWVLGHZDOOWRHQVXUHSURSHU
GLVWULEXWLRQRIFRQGLWLRQHGDLU,WVKRXOGEHORFDWHGLQ
DSRUWLRQRIWKHZDOOZKHUHWKHUHLVQRHOHFWULFDOZLULQJ
RUSOXPELQJDQGZKHUHWKHUHDUHQRREVWUXFWLRQV
LPPHGLDWHO\LQVLGHRURXWVLGH
)RUIXUWKHUGHWDLOVUHIHUWRWKH*($SSOLDQFHV$UFKLWHFWVDQG(QJLQHHUV'HVLJQ'DWD0DQXDOIRU=RQHOLQHV7R
REWDLQDFRS\RIWKHPDQXDOFDOO*($SSOLDQFHVDWRUYLVLWXVDW=RQHOLQHFRP
Outside wall
“E”
“E”
Top of Sleeve
