Dimensions and Installation Information (in inches)
GEH50DEEDSC
GeoSpring
™
hybrid water heater
For answers to your Monogram,
®
GE Profile
™
or GE
®
appliance questions, visit our website
at geappliances.com or call GE Answer Center
®
service, 800.626.2000.
Specification Revised 2/12
380110
Local Installation Regulations: This water heater must be installed in
accordance with these instructions, local codes, utility codes, utility
company requirements or, in the absence of local codes, the latest edition
of the National Electrical Code. It is available from some local libraries or
can be purchased from the National Fire Prevention Association,
Batterymarch park, Quincy, MA 02169 as booklet ANSI/NFPA 70.
Installation Information: For complete information, see installation
instructions packed with your water heater.
Power Requirements: Check the markings on the rating plate of the water
heater to be certain the power supply corresponds to the water heater
requirements.
Location: Locate the water heater in a clean dry area as near as practical to
the area of greatest heated water demand. Long uninsulated hot water lines
can waste energy and water.
Note: Because this unit draws in air from the room to heat the water, the
room must be at least 10’ x 10’ x 7’ (700 cubic feet) or larger. If the room is
smaller, there must be a louvered door. Place the water heater in such a
manner that the air filter, cover and front panels can be removed to permit
inspection and servicing, such as removal of elements or cleaning of the
filter. The water heater and water lines should be protected from freezing
temperatures and high-corrosive atmospheres. Do not install the water
heater in outdoor, unprotected areas.
Above illustration intended for dimensional reference only.
Refer to photograph for actual product appearance.
