13. Install your steering servo onto the steering servo plate. Secure
the servo to the servo mounts using the servo mount screws from
your AX-10 kit.
Note:
Notice the direction of the servo.
14. Attach the rear shock and rear lower link to the rear axle. Use two
8.5mm spacers as shown. Secure the assembly to the axle using two
3x35mm button head screws and two 3mm lock nuts.
15. Attach the rear upper links to the rear axle plate using two
3x16mm button head screws by installing the 3x16mm screws into
the rod end balls followed by the 3mm spacers and then screwing
into the rear axle plate. Secure the screws in place with two 3mm
lock nuts.
16. Attach the rear axle plate to the rear axle using two 3x14mm fl at
head screws and one 3x10mm fl at head screw (see pic.)
17. Install your body mounts, remaining electronics, wheels/tires
and body.
Replacement Parts
DTXC6624 Servo/Rear
Plate
DTXC6625 Upper/Lower
Links
DTXC6626 Mounts/Spacers
DTXC6627 Skid
Plate
DTXC8482
Rod Ends/Standoff Balls
DTXC8769
Hardware: Screws/Washers/Lock Nuts
DTXC0017INSTR
© 2010 Hobbico
®
, Inc.
GC3-A Chassis Kit
For the Axial AX-10 Rock Crawler
Disassembly of the stock AX-10 kit is required.
Chassis side plates (2)
Steering servo plate (1)
Rear axle/link plate (1)
20° bent lower rear links (2)
Lower front links (2)
Rear upper links (2)
Front upper links (2)
Lower shock mount spacers (2)
Rear upper link mount spacers (2)
Center chassis brace/upper shock mounts (4)
Rear upper shock mount spacers (2)
Front upper shock mount spacers (2)
Chassis skid plate (1)
Rod ends (16)
Rod end balls (16)
3x8mm Button head machine screws (6)
3x14mm Button head machine screws (4)
3x16mm Button head machine screws (2)
3x27mm Button head machine screws (2)
3x25mm Button head machine screws (8)
3x35mm Button head machine screws (2)
3x14mm Flat head machine screws (10)
3mm Nylon lock nuts (12)
3x6mm Flat washers (2)
3x16mm Set screws (16)
3x10mm Flat head machine screws (2)
Parts Included:
