Portable echo™ Kit Instructions
WARNING
Pozrite si príručku Dôležité informácie o bezpečnosti a produkte v balení
zariadenia GPS s produktom, kde nájdete upozornenia spojené s produktom a
iné dôležité informácie.
Assembling the Mount
Before you can assemble the mount, ensure you have a Phillips screwdriver
available to complete the assembly.
1
Insert the handle
À
into the two openings on the portable mount
Á
.
2
Attach the handle to the portable mount using two M4×0.7×40 screws
Â
and M4×7 mm nuts
Ã
.
3
Press the M6×1 nut
Ä
into the bottom of the swivel-mount base
Å
.
4
Place the swivel-mount base on the portable mount, route the echo device
power and transducer cables through the pass-through holes
Æ
, and
fasten the swivel-mount base using three M4×0.7×10 screws
Ç
.
5
Place the swivel mount
È
on the swivel-mount base.
6
Install the M6×1.0 screw
É
through the swivel-mount, and tighten to the
preferred position.
7
If necessary, pull out enough slack from the power and transducer cables
so the mount can fully swivel to the preferred positions when the cables
are connected.
Transducer
The transducer can be configured two ways. You can configure the transducer
with the included suction cup mount for use on the side or bottom of your boat.
You can also configure the transducer with the included float for ice-fishing or
dockside use.
Floating the Transducer
1
While holding the transducer arm in one hand, take a length of the
transducer cable and make a loop.
2
Insert the loop into one end of the float until the loop extends out of the
opposite end of the float.
3
Ensure the length of cable between the float and transducer is long
enough so the transducer can be suspended below the water or ice.
4
Thread the transducer through the loop at the end of float and pull tight.
Mounting the Transducer with the Suction Cup
If you purchased the echo device separately from the portable kit, before you
can mount the transducer on the transducer arm, you must find the spacers
and washers that were packaged with the echo device.
1
Attach the suction cup
À
to the transducer arm
Á
using the 1/4-20×0.750
screw
Â
.
2
Insert the rubber washer and spacer
Ã
into the transducer.
3
Pull the transducer cable back and slide the transducer into the transducer
arm.
You can route the transducer cable through the notch and opening in the
transducer arm.
4
Place the washers
Ä
on the outside of the transducer arm.
5
Insert the 10-32×1.75 screw
Å
through the transducer arm, transducer,
spacer, and washers.
6
Fasten the screw with the 10-32 wing nut
Æ
.
January 2013
000-00000-00_0A
