![background image](http://html1.mh-extra.com/html/gamermodz/xbox-one-rapid-fire-x-2/xbox-one-rapid-fire-x-2_manual_3350426001.webp)
1
Phone: (866) 205-‐5268 Fax: (813) 247-‐6200
Email: [email protected]
4951 E. Adamo Dr. Ste. 238, Tampa, FL 33605
Xbox One Rapid Fire X-‐2
Congratulations on your new Rapid Fire Controller! Please read through instructions before programming
your controller so you know what to do.
The GamerModz – SPS-‐X2 ® – allows the user to toggle between No Rapid Fire, Single Trigger Rapid Fire (left or right)
or Dual Trigger Rapid Fire. The user has complete control over how many shots per second they wish to fire at. This
mod is 100% undetectable and fully adjustable.
***You must sync and connect your controller to your Xbox One Console before programming mods***
***Must be in no Rapid Fire Mode or Single Trigger Rapid Fire Mode***
•
Turn the controller on and sync it to your Xbox One. The main LED will flash 5 times to let you know that the Mod is
available for use and working properly. (Refer to troubleshooting if the main LED does not flash five times).
•
Once the main LED is done flashing, you can turn the Rapid Fire on by pressing the sync button briefly (pressing the
sync button too long will put the controller back in sync mode).
•
By pressing the sync button once, the main LED will turn on solid – indicating you are in single trigger rapid fire. By
pressing the sync button again, the main LED will flash continuously – indicating you are in dual trigger mode.
•
By pressing the sync button again, the main LED will turn off indicating rapid fire is turned off.
Programming the Controller
(Must be in no Rapid Fire Mode or Single Trigger Rapid Fire Mode):
•
To program your “shots per second”, hold the right trigger in and press the sync button briefly (0.5 seconds)
Note: Right trigger must remain held in when pressing sync button.
•
Release the trigger when the main LED starts flashing. You will see the main LED flash 5 times indicating you are
entering programming mode.
•
Once finished flashing, you are now in “programming mode”.
•
Pull and release the right trigger the exact number of times you would like to shoot per second. Example: 11 trigger
pulls = 11 shots per second.
•
Once you have pulled the trigger the amount of times you want it to fire per second, press the sync button again
briefly (0.5 seconds).
•
The main LED will flash the amount of times you pulled the trigger to confirm the rapid fire “shots per second”. Your
controller is programmed for rapid fire.
Assigning rapid-‐fire to a trigger:
1. The rapid-‐fire mod default to “right trigger only.”
2. To set the rapid-‐fire for “left trigger only,” hold in the left trigger and briefly press the sync button. The main LED will
flash 1 time, indicating that it has changed trigger modes.
3. To set the rapid-‐fire for “dual triggers,” hold down both triggers simultaneously and press the sync button. The main
LED will flash one time, indicating it has switched to “dual triggers.”
4. To return to the right trigger default, press the sync button and the main LED will flash once, confirming that you are
back in “right trigger only.”