Pub. 42003-020C
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374
n
800-492-1212
n
Fax: 610-775-6540
G A I - T R O N I C S C O R P O R A T I O N
Handset Replacement Kit
M
ODELS
212, 213, 214,
AND
215
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information which is confidential and proprietary to GAI-Tronics. GAI-
Tronics retains all intellectual property and other rights in or to the information contained herein, and
such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
This Handset Replacement Kit is used on the following telephone models: 226, 226LD, 226C, 226CLD,
227, 227LD, 228, and 228LD.
Replacing the Handset Assembly
Polyester Elastomer Cord—Models 214 and 215
Removal of Old Handset
1.
Using the Model 233 screwdriver, loosen the 8 front panel screws.
2.
Disconnect the wiring from the handset to the printed circuit board Assembly (PCBA).
3.
Loosen the Allen set screws on the cord bracket.
4.
Remove the colored cables from the cord bracket.
Installation of New Handset
5.
Feed the colored wires through the cord
bracket.
6.
Secure the wires with the provided clip or
nut.
7.
Connect the wiring to the PCBA, as
indicated in Figure 1, paying careful
attention to the wire colors.
8.
Using the Model 233 screwdriver, tighten
the 8 front panel screws.
Note
: The polyester elastomer cord handset
assembly cannot replace an armored cord
handset assembly. The hole size on the panel
is not large enough to accept the bushing on
the polyester cord. If this option is desired, it
must be factory installed.
Figure 1. Handset PCBA
