© Copyright 2017
For more information call 01933 672180 email: [email protected]
www.fullsupportgroup.com
Assembly guide for
PureFlo
®
3000P
Always visually inspect parts before assembling. This guide presumes that filters are new,
batteries are charged, and that parts are clean and dry.
Do not enter the contaminated area until your PureFlo
®
3000P has been donned.
1. Remove filter casing by
pressing one of the side latches.
4. Pinch/push airflow adaptor
into place - short tabs face up.
7. Adjust frame to head size
using the rachet.
8. Clip fasteners on frame
to those inside hood.
9. Stretch elastic around
the airflow adaptor.
3. Press filter into place (label
face up) and reattach to frame.
2. Insert foam gasket into
the filter case lining.
5. Insert a fully charged battery.
It should ‘click’ into place.
6. Turn on and cover the air inlet
until light turns red to test.
