1
137309200A
(1003)
Washer Tech Data Sheet
This information is intended for Qualified Technicians Only.
CAUTION: DISCONNECT ELECTRICAL CURRENT BEFORE SERVICING
Please Return This Sheet to its Envelope in the Product for Future Reference
Contents Page
Error code explanation.............................................1
Diagnostics ........................................................1-2
Error Code Chart.....................................................3
Tests..................................................................4-5
Français………………………………………….........6-10
Español…………………………………………........11-15
Wiring Diagram……………………………………........16
Acronyms:
MB – Main Board (Board located inside machine on right side just behind control panel.)
MC – Motor Control
UI – User interface board (board located inside the front control panel)
DL – Door Lock
READING ERROR CODES
1.
Wake the washer up by pressing any button (except the cancel button).
2.
Press and hold the
“cancel
”
and
“start”
buttons simultaneously for 6 seconds. The failure code will appear in the
display as an E followed by two numbers.
NOTE:
E00 means no failure code experienced. Troubleshoot the problem by using charts on the pages 3-5.
If there is no error displayed and the washer momentarily starts then turns back off:
1. Listen for a relay closure inside the control shortly after the
“start/pause”
key is pressed.
2. Check the connections on the MB make sure that they are firmly snug and secured.
To clear latest stored error code:
•
Press the
“cancel”
button to enter standby mode and enable diagnostic entry.
•
Within 10 seconds after pressing
“cancel”
, press any button (except the cancel button) to wake up the control.
•
Within 5 seconds of wake up, turn the selector knob to the far left cycle and press and hold the
“cancel
”
and
center
button under the display
simultaneously for 3 seconds to enter the Diagnostic Mode. (note: to save time at wake up,
the welcome screen can be bypassed by turning the selector knob).
•
Turn the program knob clockwise 9 turns (clicks) from the Start Position. The control will signal the last 5 error codes with
E00 meaning no error experienced.
•
Press and hold the
center key under the display
and
“cancel”
buttons simultaneously for 3 seconds. The code(s) will
be cleared.
•
To return the washer to normal operation.
a) Unplug the power cord, wait 5-8 seconds, then reconnect the power cord
OR
b) Turn the program knob clockwise 2 turns (clicks) back to the Start Position (LEDs are flashing).
Press the
“cancel
” and
center button under the display
until the LEDs stop flashing.
Diagnostic Test
The diagnostic test is used to check individual component functio
n only.
TO START THE TEST:
•
Press the
“cancel”
button to enter standby mode and enable diagnostic entry.
•
Within 10 seconds after pressing
“cancel”
, press any button (except the cancel button) to wake up the control.
•
Within 5 seconds of wake up, turn the selector knob to the far left cycle and press and hold the
“cancel”
and
the center
button under the display
simultaneously for 3 seconds to enter the Diagnostic Mode. (note: to save time a
t wake up,
the welcome screen can be bypassed by turning the selector knob).
1. Upon entering Diagnostic Mode, all lights should flash for 1¼”x2” display models.
