© Freescale Semiconductor, Inc., 2004. All rights reserved.
Freescale Semiconductor
Quick Start Guide
Rev. 0.0, 08/25/2004
DEMO908GZ60 Quick Start Guide
Introduction and Default Settings
This kit contains everything you need to get started minus the +9 VDC power supply. This guide will walk
you though how to connect the board to your PC, run the pre-programmed LED test, install the correct
version of CodeWarrior Development Studio, and load an ATD (Analog to Digital) test program. Source
code for DEMO908GZ60_LED (LED test) and DEMO908GZ60_ATD (ATD test) are provided on the
Axiom CD in the “Examples” folder.
Below are diagrams of the default settings for the DEMO908GZ60 demo board. Please refer to the
DEMO908GZ60 User’s Guide on the Axiom CD for information on other configurations. All diagrams in
this guide are oriented with the MON08 header in the bottom right-hand corner. Black blocks indicate the
“on” or “installed” position of jumpers. Please check the settings before continuing.
Figure 1
.
DEMO908GZ60 Default Settings
