IV5038
-
E Edition B
fossfibreoptics.com
Page 1 of 3
Installation guide
1.
In general
This guide shows how to splice cables with pigtails in the DIN closure FPD66. Parts of the installation may be made by FOSS prior to delivery.
This closure may be used for up to 12 splices against pigtails. However; by factory terminated cables or direct termination, the closure may
hold 24 fibres using the LC Quad adapter. If less fibres than a full adapter front is used, the rest of the holes should be blinded using blind
plugs. This guide shows installation with adapters pointing left (if a wall mount bracket is used), but the closure may be used pointing right. In
such a case, think mirrored when reading this manual.
You are advised to read through the full installation guide upon beginning the installation.
Colour codes for cables delivered by FOSS may be found under the QR code/link on the right.
2. Materials
Depending on the type of installation and/or cable, the following may come to use:
PS
-
3A
-
X/45
Splice protector, 45 mm, 100 pack
4415
Cleaning kit, grease
For loose tube cables
317
-
10600
Crimp sleeve 6/2
For additional equipment for the closure itself, see data sheet. Link to the right
Contents
1.
In general
...................................................................................................
1
2.
Materials
....................................................................................................
1
3.
Splicing pigtails
..........................................................................................
2
4.
Mounting to DIN rail/wall box/raceway
....................................................
3
Splicing in FPD66
Data sheet
Fargekoder
Colour codes
