Quick
Start
:
FLIR P-620/640/660
© 2014 The Snell Group / 322 N Main St /Ste. 8/ Barre, VT 05641/ 800-636-9820
/
www.thesnellgroup.com
Page 1
SD Memory Slots
On/Off Button
LED (power)
LCD Screen
Handgrip & Controls
(Rotates)
Battery
Diopter Adjust
Data Ports
Joystick
Mode Button
Viewfinder
Preview/Save
User Defined Buttons
F1 &F2
Focus Button
Auto Manual
IR Lens &
Focus Ring
Digital Camera
Lens & Focus
Laser
Laser On/Off
1.
MEMORY:
Open the rear cover and insert an SD memory card into the upper slot marked “I” and reclose.
2.
POWER:
Insert a fully charged battery by aligning it with the slots beneath the camera body and sliding it forward
until it locks into position.
To remove the battery, you must first rotate the Handgrip clockwise to reveal the battery release button.
3.
START:
Push and release the On/Off Button on the back of the handgrip; the LED will glow green.
To turn the camera off, push and hold the On/Off Button for more than two seconds, then release.
4.
FOCUS:
You can focus the camera using any of three methods: Auto, Electric or Manual
To use Auto Focus push and release the center of the Focus Button. If this method does not give you a perfect
focus, use one of the following methods to further refine the focus.
Electric (motor-driven) focus is achieved by pushing the Focus Button to the left or right.
Manually adjust focus by turning the IR Focus Ring on the camera lens either clockwise or counterclockwise.
5.
AUTO LEVEL/SPAN ADJUST:
To automatically adjust Level and Span, push the Mode
Button to show the mode selector menu. Select the “Camera” mode icon (Fig. 1). Push in on the
joystick to return to a live image.
Push the Auto/Manual Button so that “Auto” appears in the upper right corner of the viewing
screen. The camera will now
continuously
auto correct the Level and Span settings.
6.
MANUAL ADJUST:
(Preferred Mode) As described above, make sure that the camera is in “Camera” mode.
Push the Auto/Manual Button so that “Manual” appears in the upper right corner of the viewing screen.
The Span can now be manually increased or decreased by pushing the Joystick left or right.
The Level can now be manually raised or lowered by pushing the Joystick up or down.
A
one-time auto adjust
can be performed (while still remaining in manual mode) by momentarily pressing in
on the joystick.
Fig. 1
