Installing Clipper
®
Fasteners with
the Roller Lacer
®
Gold Class
™
1. Square belt end off centerline.
2. Select the proper size hook for your
application.
3. If belt has an impression cover, skive back
1" (25mm) from the belt end.
1. Loosen hex screw to allow Face Strip
Retaining Latch to rotate out of the way.
Insert Face Strip, reposition Latch and
tighten screw.
2. The lacer head can be either manually
driven or power assisted with a cordless drill
(at least 18V power).
A. If manually driving head, use handle or
1/2" (13mm) socket and ratchet on top shaft to
index head to either end of tool.
B. if using a cordless drill, insert the
included 7/16" (11mm) nutdriver bit into the
cordless drill and place the nutdriver/drill
onto the back shaft. Set clutch to provide
minimal amount of torque necessary to embed
fasteners. Index head to either end of tool.
3. Turn knob clockwise to open rollers.
Prepare Lacer for Use:
Belt Preparation:
1. Face Strip Installation
A
B
C
5. If using hooks as shown in A or B, remove
carding paper at this time. If using hooks
as shown in C, remove carding paper after
installing hooks.
CONTINUOUS
LACING SLOTS
4. Insert hooks into the first active slot of the
face strip. Secure with lacer pin.
FIRST ACTIVE SLOT
6. Lift Belt Support Shelf up and pull into
locked position.
HEX SCREW
LATCH
TOP SHAFT FOR
MANUAL DRIVE
BACK SHAFT
FOR POWER
ASSISTED DRIVE
TURN KNOB
CLOCKWISE TO
OPEN ROLLERS
BELT SUPPORT
SHELF
