GAUGE PANEL
9369
1
AIR COMPRESSOR
9377
1
VALVE BLOCK
9357
1
PRESSURE SENSOR
9054
2
WIRE HARNESS
9371
1
AIR LINE
0938
1
MALE FITTING
3055
1
TEE FITTING
3025
2
3/16" FLAT WASHER
9
21-8392
07-11
NAD-37281-3
2491
PARTS LIST
INSTALLATION INSTRUCTIONS
Congratulations on your purchase of a Light Duty Elec-
tronic Air Command™ kit. This kit was designed to
provide inflation control of your air helper springs. This
kit will be an asset to your vehicle, meeting nearly all of
your air supply needs.
Please take a few minutes to read through the
instructions to identify the components and learn how
to properly install your Light Duty Electronic Air Com-
mand™ kit.
NOTE:
The Light Duty Electronic Air Command™ kit can be
used with all air helper spring products. If you are
installing an air suspension system, do not install the
air line tubing to the air springs as stated in the sus-
pension system instruction manual. If you are add-
ing the Light Duty Electronic Air Command™ kit to
an existing air suspension system, you will need to
deflate the air springs and remove the air line tubing.
NOTE ON CONNECTING AIR LINE TUBING
Cut the air line tubing as squarely as possible. To con-
nect the air line tubing to the fittings, push the tubing
into the fittings as far as possible. If for any reason the
tubing must be removed, first release the air pressure
from the air helper spring. Push the collar towards the
body of the fitting and then pull out the tubing. To reas-
semble, make sure the tubing is cut squarely and push
the tubing back into the fitting.
1/4" FLAT WASHER
4
1/4"-20 X 2-1/2" HEX HEAD BOLT
2
10/32" X 3/4" MACHINE SCREW
1
10/32" X 1" MACHINE SCREW
4
1/4"-20 NYLOCK NUT
2
10/32" NYLOCK NUT
5
VELCRO TABS
4
NYLON TIE
15
Light Duty Electronic Air Command
™
TOOLS REQUIRED:
CENTER PUNCH
3/16" DRILL BIT
9/32" DRILL BIT
3/8" DRILL
WIRE CRIMPERS
3/8" WRENCH
1/2" WRENCH
5/8" WRENCH
7MM WRENCH
PHILLIPS SCREWDRIVER
PSI
BAR
