1
Installation Instructions for
Insert the shade into the fixture and onto the brackets, then install the endcaps to both ends of the shade and secure them
in place by screwing the endcap screws into the brackets.
For Models OL11201, OL11202, OL11203 Only:
Temporarily install the mounting plate to the electrical box with two
mounting plate screws.
For Models OL11201, OL11202, OL11203 Only:
Mark the anchor hole locations on the mounting plate and remove the
mounting plate.
For Models OL11201, OL11202, OL11203 Only:
Drill appropriate size holes at the marked locations and install the
anchors.
Secure the mounting plate to the electrical box with two mounting plate screws.
For Model Numbers OL11201, OL11202, OL11203 Only:
Screw the anchor screws into the anchors.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white driver wire to the neutral power line wire with a wire nut.
Connect the black driver wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws.
1
2
3
1A
4
JUNCTION BOX
MOUNTING
PLATE
5
6
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized
esting aboratory”
N
R
T
L
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is suitable for wet locations.
This product may be dimmed with a low voltage electronic dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
ANCHOR SCREW
7
FIXTURE SCREW
Ledgend Outdoor Wall
1.0
O 11200_OL11201_OL11202_OL11203
L
O 11200, O 11201,
L
L
O 11202, O 11203
L
L
Wall
8
9
ANCHOR
ENDCAP
SHADE
ENDCAP SCREW
BRACKET
MOUNTING
PLATE SCREW
9
10
8
1
1
4
4
5
5
6
6
10
10
