2.5M
3M
6.6M
5.6M
8M
OBSERVATION AREA
2.5M Height - Beam Pattern
3M Height - Beam Pattern
OVERVIEW
MOTION SENSOR 360 - VOLT FREE
The Faradite Motion Sensor 360
- Volt Free is a low profile passive
infrared ceiling mounted motion
sensor. It’s designed for use with
home/building/lighting control
systems that have volt free / dry
contact inputs.
At 2.5M
it gives a 5.6M * 6.6M
detection area.
At 3M
it gives a ~8M diameter, as
shown below.
The following conditions have to
be met to detect motion:
1.Movement speed: 1.0m/s
2.Target concept is a human body
(Min object size: ~700×250mm)
3. The temperature difference
between the target and the
surroundings must be greater
than 4
°
C when mounted at 5M
TECHNICAL DATA
Power supply
(consumption)
5V-24V DC @ 24V
(3mA)
Solid state relay -
max load current
80ma
Solid state relay -
on resistance
16 OHMS
Solid state relay -
off-state leakage
current
1uA
Default state
Normally open
Ambient
temperature
0-50
°
C
(indoor only)
IP rating
IP20
Range
(Note 1)
5M
Max mounting
height
3m (for optimal
performance)
Motion output
timeout
(see motion
output diagram)
1 second
Mounting hole
35mm (40mm Fire
rated)
Push-fit
connector
AWG 20- 24 CAT5 /
CAT6 / CAT7
Standards
EN 61000-6-1
EN 61000-6-3
ELECTRICAL CONNECTIONS
It is recommended to use CAT cable
to connect the motion sensor to the
control system. Stranded cable can
be used (20-24 AWG) but please
insert the supplied tool to open the
spring before inserting the wire.
1: Strip the cable back 6mm
2: Push into circular hole
3: To remove the wire insert the
supplied tool or a small screwdriver
in the slot behind the wire
EQUIVALENT CIRCUIT
MOTION OUTPUT
TIMEOUT
1 SECOND
OPEN
CLOSED
-
0V/GND
VOLT FREE RELAY
+
5V-24V DC
VOLT FREE RELAY
CLOSED DURING
MOTION
(NORMALY OPEN)
Note 1: Please note that the specified range is 5m but under optimal conditions the sensor
might detect movement at a much longer range
Strip back
Push in
Remove
Pull to remove connector from motion sensor
X
Y
X
Y
FIRE RATING
The stand-alone Motion Sensor 360
- Volt Free is not fire rated.
To achieve a 60 minute fire rating to
BS 476: Part 21 1987, the optional
Fire IDR must be fitted to the
Motion Sensor 360 - Volt Free.
The Fire IDR is an optional extra.
RELAY
NOTE: After applying power, the sensor will calibrate for roughly
8 seconds; during this period no motion will be reported.
FAR-M360-W-VOLF (WHITE) ----- FAR-M360-B-VOLF (BLACK)
X
Y
