EZ Privacy Gate Kit Assembly Instructions
Vinyl Fencing Made Easy
www.ezfencecenter.com
Made
in the
USA
Cut to Size
Pocket Rail & T&G Pickets
Sold Seperately
• 4 Upright Metal Support
• 4 Pocket Rail Metal
Support
• 1 PVC Glue
• 2 Post Flat Caps
• 2 Upright Post
• 1½" & ¾" Pan Metal
Sheet Screws & Vinyl Caps
• Gate Lock & Hinges
EZ Privacy Gate Kit
Cut to Size Pocket Rail and T&G Pickets
Not Included
PLEASE READ INSTRUCTIONS BEFORE ASSEMBLY
During assembly, vinyl components should be laid on a non-abrasive surface (i.e. cardboard or drop cloth) so as not to scratch.
• Use care when applying PVC cement, as it
dries quickly. Vinyl should be cleaned with
a mild detergent and non-abrasive cleaning
pad or sponge.
• Gates should not be made any wider than
48", to avoid sagging from hinge post.
TOOLS NEEDED
• Measuring Tape / Ruler
• Pencil
• Screw Driver (Phillips #2)
•
Drill with �⁄��” bits
• Drop Cloth
• Square Level
• Rubber Mallet
• Vinyl components should be assembled
without using excessive force, to avoid
breakage.
• All hinge posts properly installed should have
steel insert and be filled at least 75% with
concrete.
•
Assemble gate after fence installation, to
accurately locate hinge and latch post and
proper width size.
•
Cut Top and Bottom rail 2" shorter than
distance between hinge and latch post.
For Example: If the gate opening is 44" cut
Top and Bottom rail to 42".
Top Uprights Post
Step 7
Post
Flat Caps Installation
Flat Cap
USP © 2015
Put a small amount of Vinyl Glue on all sides of the Post Flat Cap and gently tap the Post Flat Cap into the top of
the two Uprights Post and wipe off any excess Vinyl Glue with damp cloth (Fig. 11).
EZ Privacy Gate Kit Assembly Instructions
Completed Privacy Gate Kit
Front Side
- all smooth
Back Side
-with screw caps
Vinyl Glue
Flat Cap
Vinyl Glue
Fig. 11
Need Help or Info.
Call us at 1.888.754.6507
