1
Thank You for your purchase of an
Expert Mount. The SL001 is designed
to securely attach a Flat Panel LCD to
a cabinet or an armoire. It will allow
the ability to pull the TV out and
swivel.
Safety Warning: If you do not understand these
directions, or have any doubts about the safety of
the installation, please call a qualified contractor
or contact Expert Mounts at 855.5MOUNTS or
www.ExpertMounts.com. Check carefully to
make sure that there are no missing or defective
parts. Our customer service representatives can
quickly assist you with installation questions and
missing or damaged parts. Replacement parts for
products purchased through authorized dealers
will be shipped directly to you. Never use
defective parts. Improper installation may cause
damage or serious injury. Do not use this product
for any purpose that is not explicitly specified by
Expert Mounts. Expert Mounts will not be liable
for damage or injury caused by incorrect
mounting, incorrect assembly, or incorrect use.
Please call Expert Mounts before returning
products to the point of purchase.
Step 1: Mounting the slide unit.
Properly align the slide unit to the desired
location on the surface the SL001 is to be
mounted on. Using a drill and a ¼” drill bit, drill
a hole in each location (6 total) in the Shelf.
(Make sure each slide bracket is equal distance
from the leading edge of the shelf)
Note: The front edge of the mounting bracket is
even with the mounting surface for the TV. (For
Example: If your TV is 3” thick and you want
the recess the TV 1”, you would need to start the
mounting bracket 4” from shelf edge. If you
want the TV to be flush with the edge, set the
mounting bracket back the same depth of the TV.
If you want the TV to protrude 1” you would set
the mounting bracket (3”-1” =2”) 2” from the
leading edge of the shelf.)
WARNING: It is the responsibility of
the installer to verify the surface the
SL001 is mounted to is secured so that
it will NOT tip forward when the
television is pulled out into its
extended position. The mounting
surface must be capable of supporting
the total weight of the television and
the mount.
Step 2: Installing the support pole
Thread the support pole into the female coupler
on the top of the slide unit. The pole may not
thread all the way into the coupler. Make sure
that the pole is threaded far enough in so that the
set screw comes in contact with the threaded
portion of the pole.
