TURF TRACER
®
S-SERIES LP
Setup Instructions
For Serial Nos. 312,000,000 & Higher
Loose Parts
Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer
extranet.
Dealer Pack
Part #
Description
Qty.
Use
323-6
Screw, HH 3/8-16 x 1 inch
4
3290-357
Nut, Whizlock 3/8-16 inch
4
98–5975
Washer, Spring Disc
4
Installing the handle assembly.
104-8300
Nut-Nyloc 5/16-18 Flg
4
3230-1
Bolt-Carriage 5/16-18 x 3/4
4
Installing the LPG tank bracket.
1-806003
Hairpin, Cotter
1
3272-5
Pin, Cotter 3/32 x 1/2 inch
1
1-808280
Pin, Clevis
1
Installing the speed control rod.
322-9
Screw, HH 5/16-18 x 1 3/4 inch
2
3296-29
Nut, Nyloc 5/16-18 inch
2
3220-16
Nut, Jam 3/8-24 inch LH
2
Installing the wheel drive linkages.
1-303335
Tie, Cable
2
1-303287
Tie, Cable
4
Connecting wire harness.
103-2106
Key, Exmark Logo
1
1-603511
Key, Standard
1
Fill out the online warranty registration
form and place keys into literature
pack.
Literature Pack
Part #
Description
Qty.
Use
—
Manual, Operator's
1
Read before operating the machine.
—
Manual, Engine Operator's
1
Read before operating the machine.
Uncrating the Unit
1. Leaving the unit on the pallet, place the upper handle
assembly and the LP tank bracket at the rear of the
machine.
2. Remove the bolt bag from under the mower deck
belt shield.
3. Refer to the parts manual to help you identify and
locate the parts and their proper position.
Installing the Handle Assembly
1. Position the lower end of the handle assembly on
the outside of the upper rear section of the fuel tank
and handle support.
2. Install four 3/8-16 x 1 inch bolts, four spring disk
washers from the outside in. Secure using four
3/8-16 whizlock nuts on the inside of each handle
support and tighten until the spring disk washers are
flat (Figure 1).
Note:
Be sure the cone of the spring disk washer is
against the head of the bolt.
© 2011—Exmark Mfg. Co., Inc.
P.O. Box 808
Beatrice, NE 68310
Part No. 4501-050 Rev. A
Printed in the USA
All Rights Reserved
