1
SP819
Outdoor PIR Motion Detector
General Introduction
The SP819 Outdoor Motion Detector is a U-Net 4.0 enabled device and is fully compatible with any
U-Net enabled network. The device can be set up in a U-Net network to communicate directly with other
end devices such as lighting controllers, or to report directly to a U-Net gateway.
Product Overview
Setup to report directly to a U-Net gateway
Its great compatibility with our U-Net family security products makes it suitable for smart home cloud
based platforms such as Homesys. The lux level and the timer set by knobs will be ignoring . It features a
PIR motion detector to detect movement in a protected area.
This device can also be used as a basic motion sensor for indoor security application.
Setup directly with other end devices such as lighting devices
This motion detector is primarily designed for outdoor lighting control application. It features a PIR motion
detector to detect movement in a protected area and a lux sensor for determining brightness of its
surroundings. It comes with a built in timer to set the duration for light turn on. The lux level and the timer
can be set through knobs on the device itself. If the PIR detects motion when lux level falls below a
preset setting, the device will transmit a signal to turn on the outdoor lighting (or indirectly through
gateway) and then later turns it off when its timer has elapsed.
M
Front Cover
Q
Battery
N
Motion Sensor
R
Rear Cover
O
Time-off / Lux Knob
˕
7 Tamper Switch
P
LED indicator (hidden behind lens)
Binding with Homesys
1
Log into the Homesys account from web browser.
2
Select “System” then “Add a Device”.
3
Select “PIR Detector SP819”.
4
The following screen will appear. Remove the screw and open the battery cover. Insert 3 AA
batteries as shown on the picture, then press “Next Step”.
2
5 The following screen will appear, this means the gateway start to bind. Please press the binding
button for 4s then release. The LED will start blinking. This means the SP819 is entering binding
mode too.
6
The screen below will appear if the process is successful.
7
Time-out will occur if the binding process was unsuccessful. Please refer to the “Manual binding”
section.
Note
: Leave the detector with the rear cover open to prepare for testing.
Testing
Warm-Up
It will take approximately 1 minute to warm up the Detector after a battery is inserted. During this period
the LED will flash red slowly. When the LED turns red for 5 seconds, it implies warm-up procedure is
complete and the detector is ready for detection.
Testing
1.
Go to SECURITY, and set it to DISARM.
2.
GO to SYSTEM, and select the PIR Detector SP819, then press the “Test this device” icon.
3.
Please walk within the PIR sensor detection range.
