Copyright 2020 EtherWAN Systems, Inc.
Page 1
All Rights Reserved
E
X17908
02/25/2020
W70G-E17908XQ2
1
Unpacking
Unpack the items. Your package should include:
One EX17908 Web-Smart switch
One external power adapter
One CD containing this user’s guide
If items are missing or damaged, notify your
EtherWAN representative. Keep the carton and
packing material.
2
What Else You Need
Category 5 or better Ethernet cables
Notebook PC with Ethernet (RJ-45) Interface
and installed Web browser
3
Select a Location
Desktop installations: Mount on a flat table
or shelf surface.
Rack installations: Use a 19-inch (48.3-
centimeter) EIA standard equipment rack
that is grounded and physically secure.
Identify a power source within 6 feet (1.8
meters).
Choose a dry area with ambient temperature
between 0 and 40ºC (32 and 104ºF).
Do not cover fans on the rear and side.
Keep away from heat sources, sunlight, warm
air exhausts, hot-air vents, and heaters.
Be sure there is adequate airflow.
Keep the switch at least 6 ft (1.83 m) away
from the nearest source of electromagnetic
noise, such as a photocopy machine.
4
Connect to the Data Ports
The switch provides eight 10/100/1000 Mbps RJ-
45 ports that can connect to Power over
Ethernet (PoE) devices, such as an IP surveillance
camera or a Voice Over Internet Protocol (VoIP)
phone.
A.
Insert one end of a Category 5 or better
Ethernet cable into a switch port.
B.
Connect the other end into the Ethernet port
of the device.
C.
Repeat steps A and B for each additional
device you want to connect to the switch.
5
Apply AC Power
A.
Connect the female end of the supplied AC
power adapter cable to the power receptacle
on the switch rear panel. Connect the other
end to a grounded 3-pronged AC outlet.
B.
On the switch rear panel, move the ON/OFF
switch to the ON position.
When you apply AC power:
All green
PoE
and
Link/ACT
LEDs blink
momentarily.
The fans start.
The yellow
Power
LED goes ON.
The
Link/ACT
LEDs for every port connected
to a device flash, as the switch conducts a
brief Power On Self-Test (POST).
6
Configure the Switch
After the switch passes its POST, perform a basic
configuration of the switch.
A.
Connect an available 10/100/1000 Mbps RJ-
45 switch port to a PC using a Category 5 or
better Ethernet cable.
B.
Confirm that the
Link/ACT
LED for the switch
port to which the PC is connected is ON.
C.
Configure the PC’s TCP/IP settings to use the
subnet 192.168.2.2.
D.
in the address bar and press Enter.
E.
At the Password screen, type
admin
as the
default password, and then click
Apply
.
EX17908 Web-Smart Switch Installation Guide
Continued on next page
