![background image](http://html1.mh-extra.com/html/esl/esl-emg-4dc-series/esl-emg-4dc-series_instructions_2427157001.webp)
EMERGENCY DRIVER
INSTRUCTIONS
ESL-EMG-4DC Series
PAGE 1 OF 5
1.
To prevent electrical shock, switch off the main power supply until installation is complete and AC power is
supplied to this product.
2.
This product requires an unswitched AC power supply of 120-277 VAC, 50/60Hz.
3.
Make sure all connections are in accordance with the National or Canadian Electrical Code as well as any
local regulations.
4.
To reduce the risk of electrical shock, disconnect both normal and emergency power supplies and connector
of this product before servicing.
5.
This product is for use with an emergency LED lighting load with a maximum rated voltage of 60 VDC, and a
maximum rated current of 1A. It can be provide a minimum of 90 minutes of illumination when under the
emergency mode.
6.
The ESL-EMG-4DC are UL Listed for both factory and field installation. For field installation please see
instructions on page 5.
7.
This product is suitable for use in dry or damp locations. Do not mount it near gas heaters, air outlets or other
hazardous locations.
8.
Use this product in 32°F (minimum) to 122°F (maximum) ambient temperatures.
9.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition and
void the warranty.
10.
Do not use this product for anything other than it’s intended use.
11.
Installation and service should be performed by qualified service personnel.
12.
This product should be mounted in locations and at heights where is will not easily be subjected to tampering
by unauthorized personnel.
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Copyright © 2018 ESL Vision, LLC. All rights reserved. Rev: 08/15/2018