All rights reserved. Reproduction as well as electronic duplication of this user manual, complete or in part, requires the written consent of
ESERA-Automation or E-Service GmbH. Errors and technical modification subject to change.
ESERA-Automation, E-Service GmbH 2019
www.esera.de
11233 V1.0 R1.1 Manual
Page 1 of 7
Art. No. 11233
User Guide
Binary Output / Dual Switch Module
for 1-Wire Bus
Two changeover relays with 10A continuous power rating
Control inputs for button and 1-Wire Bus
LED indicator for activated relays
Switching of direct power and alternative power consumers,
e. g. lighting, heating or sockets
DIN rail housing for switchboard assembly
Easy software-based control
Low space requirement in switchboard
Easy to assemble
New, with a DS2408 interface
1
Introduction
Before you start assembling the
Dual Switch Module
and before you take the device into operation, please read
these assembly and operating instructions carefully to the end, especially the section referring to the safety notes.
2
Product description
With the
Dual Switch Module
it is possible to connect direct power consumers and alternative power consumers
with an output of up to 10A continuous power. It is also possible to control motors.
The
Dual Switch Module
can either be controlled directly by an external button or by button on the module top
side, independent of the 1-Wire interface. For switch operation only 12 V power is required. Thus, a high
reliability, e.g. for switching of lightings, outlet circuits or other consumers can be reached, even in case of a
breakdown of a central control / software.
To operate the switch module we recommend the use of one of our 1-Wire Hub modules.
