Art. No. 11336
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH, ESERA-Automation 2020
www.esera.de
11336 V2.0 R1.0 Manual
Page 1 of 9
User Guide
1-Wire Gateway 11 Modbus TCP
1-Wire Gateway for autonomous communication between
PLC and a 1-Wire Sensor and Actuator network
Data evaluation of all 1-Wire modules in 2 seconds
increments
Modbus data output as TCP protocol
Processed sensor- and actuator data
Status of each sensor and actuator can be called up
Easy configuration
No extra drivers needed
Data storage in case of loss of communication to the host
system (optional)
Power supply for 1-Wire network
Designed for all dimensions of 1-Wire networks
DIN rail enclosure for switchboard assembly
Wide range of power voltage
Management of all ESERA-Automation 1-Wire modules and
many of standard 1-Wire sensors and actuators (switch-
module)
1
Introduction
Before you start assembling the
1-Wire Gateway 11 Modbus TCP
and before you take the device into operation,
please read this assembly and operating instruction carefully to the end, especially the section referring to the
safety notes.
We recommend to use Config-Tool 3 for all kind of setup and configuration tasks. Please find the latest release
on our website at,
. Please also refer to the Help/Support section to find the user guide for Config-
Tool 3.
2
Product description
Standard Modbus TCP protocol
You can use your industrial controller, e.g. SPS and standard TCP protocol to connect to the 1-Wire
Gateway 11. Addressing is similar to other Modbus systems and easy to handle. You can use addresses for
system data, sensor data and actuator devices. A complete address list including all available data points is
available for
on our webpage. These addresses are also available within the ESERA configuration
software Config-Tool 3.
3
Auto-E-Connect® Support
The ESERA
Auto-E-Connect®
1-Wire Plug and Play system will be used for the
1-Wire Bus supported. This enables fully automatic configurations of 1-Wire sensors
and actuators on the 1-Wire bus. It is optimized for industrial applications and
enables significant added value beyond the sensor and chip data.
The Auto-E-Connect function automatically recognizes ESERA chips, sensors and actuators, starts suitable
libraries and outputs fully formatted data.
