Instructional Manual Continuous Ink System for use in Epson WF 600/WF610/NX515/NX510
NOTE: The following instructions and pictures are for reference only. Besides removing the cartridge
carrier cover, you do not need to alter your printer in any other way such as cutting or drilling any
parts of the printer.
Before using this product, please read and follow the instructions. After opening your package, make sure to check that all
the accessories shown in figures 1-1 through 1-3 below.
Conduct Parts Check:
1. Accessories
a. Continuous Ink System (1) b. Air breather plugs (4) & Syringe (1) &Screwdriver (1)
c. T shape Adhesive Pad (1) & square adhesive pad (2)
Fig. 1-1 Fig. 1-2 Fig.1-3
2. Set-Up Continuous Ink System (CIS)
a. Before installation, lay out all your parts in front of your printer.
b. Check your system for any leakage, and make sure your tubing system is tightly connected and straight.
c. The ink tank has two chambers per color, the front chamber is to hold the ink and the rear chamber is to control the
flowing pressure.
It is important that the rear chamber contains only a small amount of ink (as little as possible).
The ink
should reside in the front chamber. To remove any excess ink from the rear chamber you need to first make sure the ink tank
plugs are tightly closed, then tilt the ink tank forward to make the majority of the ink flow into the front chamber. (Fig. 2-1
through Fig. 2-3)
Fig.2-1 Fig.2-2 Fig.2-3
d. Place the CIS on the right hand side of the printer as shown (Fig.2-4),
and keep it at the same level as the printer.
e. Hold down the ink tank with one hand and unplug the original air stoppers as shown (Fig.2-5), make sure to save
these for later use.
f. Install the Air Breather wider end into the ink reservoir tank, making a snug fit (Fig.2-6).
Caution: Make sure not to push the breathers too tight as it could crack the tank. Also when removing the air breathers
from the tank use caution to avoid cracking.
Fig.2-4 Fig.2-5 Fig.2-6
