TWINSTAR NANO
Manual / Warranty
ENBION
1. Product composition
TWINSTAR IC (Controller)/TWINSTAR NANO/Adapter/Extension Cable/
Suction cup(Large 2, Small 2)/Power cord
2. Names of parts
3. Mode Selection
If you press power button once, power will be switched, M1 will be
selected by pressing twice, M2 by pressing three times. M1 is selected
for 45 cube tank (45cmX45cmX45cm)~60cm(60cmX45cmX45cm), while
M2 is for 90cmX45cmX45cm (or 75cm) tank. Both of modes are
purpose for inhibiting algae in planted aquarium.
Power button/
Mode selection
button
Mode selection indicator
(Left : mode1, Right : mode 2)
Power input
terminal
Power output
terminal
< TWINSTAR IC >
< TWINSTAR NANO >
4. Installation
Product Feature
1
Inhibit green algae and promote plants growth
Inhibit phytoplankton initial growth and reproduction.
Activate microelements to promote plants growth.
Promotion of plants growth activates photosynthesis to stabilize
ecosystem.
2
Safe because of coexistence with filter bacteria
As there is no residual toxicity, it is limited to aerobic bacteria.
Compared to UV sterilizer, TWINSTAR does not work steadily so
regenerating and recovery of filter bacteria is rapid.
3
ALC program is intelligent management algorithm
Aquarium environment changes according to initial, middle, last
stage, sterilizing intensity and operation cycle is intelligently
designed to change by time series.
As ALC program can simply choose a mode according to a aquarium
capacity, it is very easy to use.
About Product
TWINSTAR NANO is specialized for inhibiting algae of 45 cube tank
~90cm tank. Please use the product with appropriate capacity and
purpose.
For the best performance, Install TWINSTAR NANO at the bottom of
water drain in tank. Please do not install near water draining rapidly.
It may be cause of performance decrement.
1) Put the large suction sups on the NANO and install inside tank. We
recommend the bottom area of a tank.
2) Put the small suction cups on the side of TWINSTAR IC
3) Put on TWINSTAR IC on back side of a tank.
4) Connect TWINSTAR NANO’s cable and TWINSTAR IC’s cable with.
5) Connect TWINSTAR IC’s Power input terminal and Extension cable.
Connect adapter and extension cable with.
6) If press Power button once, power will be switched and after select
M1 or M2, TWINSTAR starts operating as lamp blinking.
