EFM DEG 2a, Manual

Page: 1 / 3

DEG 2a - Dual ADSR
Dual ADSR Envelope generator.
Features...
●
Common Gate
●
+/-12 or +/- 15V
Assembly
●
Press the overlay on the panel blank
●
Drill and clean the holes
●
Remove the application tape and cutouts
●
Mount the jacks, switches, pots ect... to the panel.
●
Install the resistors
●
Install the IC sockets
●
Install the capacitors
●
Cut and solder header strip pins in pads used to connect wire to the board
●
Plug the ICs into their sockets
●
Mount the L-Brackets to the board with 440 screws and nuts, using the non threaded end of the bracket
●
Mount the board to the panel with 440 screws using the threaded end of the bracket
●
Wire the panel mounted parts to the header pins.
Notes
●
D3 and D6 are mounted to the control pots. Do not install them on the pc-board.
●
The LEDS are no longer used you can also omit R12 and R17.
●
For faster envelopes change R9,10,11,14,15 and 16 from 1K to 100ohms. Change C6 and 8 from 10uF to 4.7uF
-
Schematic