1
91712
S e r v i c e P u l l o u t
I n s t a l l a t i o n
Service Pullout
Rev. __ Date:
TOOLS REQUIRED
(1) 7/16” Socket wrench (not supplied)
(1) 3/8” Socket wrench (not supplied)
(1) 5/32” Allen wrench (supplied)
(1) Level (not supplied)
(1) Rubber mallet
IMPORTANT!
The LMS Full Frame
must be level
before installing the Service Pullout.
1. Determine the desired height of the Service Pullout
and then insert the hooks* on the back of the unit into
the slotted standards and push down. See figure 2a.
To ensure that the hooks are seated, tap the top rear
corners with a rubber mallet.
The Service Pullout can be installed at four different
heights at one inch increments. The minimum height is
34”, the maximum height is 43”. See figure 1.
POSITIONING THE SERVICE PULLOUT
Figure 1
43” Maximum
34” Minimum
Service Pullout
LMS Full Frame
ITEM NUMBERS
ALLEPSD2430
ALLEPSD3030
ALPEPSD2430
ALPEPSD3030
*NOTE
:
It is suggested that the hooks be bent out
slightly to ease insertion into the slotted standards.
See figure 2b.
Figure 2a
Hooks
Slotted standards
Hook Plates
Figure 2a
Hook
Bend out slightly
