Mag Drive Pumps
Instructions for Operation • Safety • Warranty
Thank you for purchasing the EasyPro Mag Drive pump.
This pump is a magnetically driven water pump. It contains no
oil, rotating shafts, shaft seals or bearings. This pump combines
simplicity of design with the most energy efficient operation of
any pump. All electrical components are encapsulated in epoxy.
The impeller assembly consists of impeller blades attached to a
magnet and is easily replaced should the need arise. There are
threaded discharge and intake ports on all models.
Safety & Electrical Connections
1. Always disconnect the electrical supply before handling, maintaining, repairing or installing any
pond equipment.
2. Connect this product only to a 110 volt receptacle that is protected by a Ground Fault Circuit Interrupter
(GFCI).
3. The pump must be fully submersed underwater at all times when operating.
4. Never let the pump run dry, as this can damage the impeller, over heat the pump and possibly burn out
the pump.
5. Do not use this product in bathrooms or swimming pools.
6. All electrical work must be performed by a qualified technician. Always follow the National Electrical
Code (NEC) or the Canadian Electrical Code as well as all local, state and provincial codes. Code
questions should be directed to your local electrical inspector. Failure to follow electrical codes
and OSHA safety standards may result in personal injury or equipment damage. Failure to follow
manufacturer’s installation instructions may result in electrical shock, fire hazard, personal injury or
death, damaged equipment, provide unsatisfactory performance, and may void manufacturer’s warranty.
7. When installing fittings into the pump, do not overtighten as this could crack the housing and void
the warranty.
8. Do not remove the pre-filter or the pre-filter cover from the pump as this will cause excess debris to
enter the pump and may void the warranty.
Troubleshooting:
If the pump fails to operate, please check the following before contacting EasyPro:
Note: Always disconnect from electrical outlet before handling the pump.
1. Check the GFCI circuit breaker or try another GFCI electrical outlet to ensure the pump is getting power.
2. Check the tubing for kinks and obstructions. Check filter cover and foam filter for blockage. Follow
cleaning steps in the maintenance section if blockage is suspected.
3. If necessary, remove and clean the impeller assembly.
EP120 • EP200 • EP400 • EP600 • EP850
EP1050 • EP1350 • EP1750 • EP2200 • EP3200N
1
Components included with EP1350, fountains may vary
