DESCRIPTION
The TSRP Standard Power Connection Kit is for use with
all versions of Easy Heat self regulating cables for pipe
tracing applications. It is also compatible with any heater
cable smaller than 0.44" (11mm) in diameter.
Note:
This kit contains materials to connect power to
either (1) or (2) heater cables through a common stand-
off and junction box.
TSRP Power Connection Kit Installation Instructions
KIT CONTENTS
1 Junction Box
2 Power Terminations
2 Warning Labels
1 Box Adapter
1 Terminal Block
1 Gasket
1 Conduit Locknut
1 Tube of Silicone
1 Sealing Grommet
2 End Seals
1 Stand-off
2 Pipe Clamps
1 Uninsulated Splice Connector
a
WARNING!
• Article 250 of the National Electrical Code requires all metallic conduit and fittings terminating at the
junction box to be effectively grounded by approved means.
• Article 427 of the National Electrical Code requires that all heaters shall have grounded metal coverings
and ground-fault protection.
• If nuisance tripping of ground fault breakers occurs due to condensation in the junction box, electrical
connections should be moisture-proofed by suitable means!
• Minimum installation temperature -40°C (-40°F).
14036-001 Rev. 3
©2010 EasyHeat
*ITEMS NOT INCLUDED IN KIT
SILICONE
Power Termination
Terminal Block
Junction Box
*Heater Cable
Conduit Locknut
Gasket
Box Adapter
Sealing Grommet
Stand-off
End Seal
*Heater Cable — Shown at
Top pf Pipe for Clarity Only
Pipe Clamps
Label
Box Cover Gasket
Box Cover
*Conduit Con-
nector
*Flex
Conduit
*Conduit Power Supply
*Low Point Drain Fitting
(If Required)
