HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE WHEELS, HANDLE ASSEMBLY AND
CONTROL ROD. IT SHOULD TAKE APPROXIMATELY 10 MINUTES WITH THE USE OF TWO 7/16” WRENCHES AND 1 PAIR
OF PLIERS.
Clean the impeller plate after each use. Material build up on the impeller blades will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
When using Rock Salt remove salt from the hopper daily. Rock Salt will reconstitute back into a solid block over night
lubricant to prevent corrosion.
1.
Open carton and remove the handle assembly, wheels, and spreader from
carton.
2.
Turn spreader upside-down on to the hopper.
90365 ICE MELT SPREADER
SLIDE
GEARBOX &
AXLE ASSEMBLY
Lower
Handle
Frame
Brace
Cross Brace
Axle Bushing
Axle
Bearing
3.
Ensure that the axle bearings are pushed into the axle
bushing on both sides as shown. Install drive wheel (both
wheels are interchangeable) to axle using pin hole nearest to
lower handles as shown. Insert 2” cotter pin through wheel and through axle. Bend with pliers to prevent pin from falling
out.
4.
Install coast wheel to axle, then using outside pin hole as shown, insert 1” cotter pin through axle (not thru the wheel).
Bend with pliers to prevent pin from falling out.
2” Cotter Pin
1” Cotter Pin
Coast Wheel
Drive Wheel
PLEASE CALL
IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER.
SUPPORT: 574-848-7491 or [email protected]
ASSEMBLY & OPERATION
2019 OCT REV
PAGE 1
