![background image](http://html1.mh-extra.com/html/eaelec/z-scale-ford-c-series-truck-kit/z-scale-ford-c-series-truck-kit_assembly-instructions_3268188001.webp)
Assembly Instructions For Z-Scale
Ford C Series Truck Kit
Page 1
This kit is a scale model of a Ford C600
medium duty truck. The C series was a cab-
over-engine design introduced in 1957. The kit
contains all the parts needed to build a propane
tanker.
3D printed parts Included in the kit:
A. 1 chassis
B. 1 cab
C. 1 propane tanker bed
Required to complete the kit:
Paint - see painting guide on page 2.
Glue - Slow setting CA is best.
Tools -
1. X-acto knife with a sharp #11 blade.
2. #400 and #600 sandpaper.
Also included: 1 decal sheet.
www.eaelec.com
Made in Canada
WARNING: CHOKING HAZARD
Keep out of reach of small
children!
NOTE: THESE ARE NOT TOYS,
AND ARE NOT INTENDED FOR
USE BY CHILDREN UNDER
AGE OF 14. These products are
model railroad equipment and
accessories intended for use by
adults.
Parts For Propane Truck
Decal Sheet
A
B
C
The 3D printing process requires a supporting
frame during printing, see below. The printed part is
cut from the frame using flush cutters and this
sometimes leaves small bumps on the part. Use a
knife with a sharp new blade to cut away the bumps.
When trimming bumps off the wheels you should
place the wheel on a flat surface as shown below.
Putting too much stress on the wheel can cause the
axle to break. For bumps on the cab body, sanding
is recommended.
After cleaning up the bumps, paint the parts and
apply the decals as shown on the painting guide on
page 2. When everything is dry, proceed to final
assembly, using CA glue.