CAT-3:
Universal Seat Back Plates
/ December 18, 2014 / Manufactured By Custom Golf Car Supply, Inc.
www.DoubleTakeGolfCar.com
Cushion
Seat Back
Plastic
(A)
(A)
SEAT BACK PLATES INSTALLATION
IMPORTANT: Do not fully tighten hardware until instructed.
Read through all instructions before beginning installation.
PREPARE CAR FOR INSTALLATION:
TABLE OF CONTENTS:
•
2P
: Remove Factory Cushions
•
4P
: Remove Top, Rear Frames and Seat Back Support/Sweater Basket
Assembly. Install DoubleTake
®
Rear Seat Kit.
NOTE: Save original Hardware for later use.
Section 1
- 2-Passenger Plate Installation (For Star see pg 4)
Section 2
- 4-Passenger Plate Installation (For Star see pg 4)
Section 3
- Seat Back Cushion Installation
Attach the Seat Back Plates to the Seat Back
Supports using a 1/4" x 1-3/4" FHP Bolt, a 1/4" Flat
Washer (back), and a 1/4" Nyloc Nut (2x both sides
– through holes marked CC-DS).
NOTE: Fully tighten Bolts.
2 - P A S S E N G E R P L A T E I N S T A L L A T I O N
SECTION 1
UNIV SPL-2 KIT
Club Car Precedent (PD)
EZGO RXV (RX)
NOTE: For Star
mounting, see pg 4.
UNIV SPL-1 KIT
Club Car DS 2000+ (C2)
EZGO TXT (TX)
Yamaha Drive
Club Car DS 2000+: 2-Passenger Factory Supports
Club Car DS
Club Car Precedent: 2-Passenger Factory Supports
NOTE: The Seat Back Plates DO NOT
WORK with Precedent Factory Seat
Back Supports.
Precedent Mounting Clips
PROVIDES HEIGHT ADJUSTMENT FOR SEAT BACK CUSHIONS
PROCEED TO SECTION 3
DoubleTake
®
Seat Back Cushion Install
(Factory Seat Back Supports)
Install Mounting Clips to the cushion back
where indicated (A). Mount Seat Back Cushion
to factory seat back supports the same way
the factory cushion mounts.
NOTE: Fully tighten Bolts.
For 4-Passenger installation,
skip to Section 2
