![background image](http://html1.mh-extra.com/html/dometic/afm-series/afm-series_technical-installation-manual_2518656001.webp)
Literature number 32471
hydro flame
™
AFM Series Furnaces Models
AFMD16, AFMD20, AFMD25
AFMD30, AFMD35
Technical Installation Manual
English, Français (et Canada)
This instruction manual is for use by an authorized service
technician to install a
Dometic
hydro flame
™ furnace. Should you
require further information, contact
Dometic Corporation
.
This furnace design has been certified for installation in
recreation vehicles as a MSP Category III furnace. Follow this
installation instruction to insure safe operation of the furnace.
Failure to install furnace according to this installation instruction
nullifies the furnace warranty.
TO THE INSTALLER:
LEAVE THIS MANUAL WITH THE
APPLIANCE.
TO THE CONSUMER:
RETAIN THIS MANUAL FOR
FUTURE REFERENCE.
WARNING
Installation of this appliance must be made in accordance with the
written instructions provided in this manual. No agent,
representative or employee of
Dometic Corporation
or other person
has the authority to change, modify or waive any provision of the
instructions contained in this manual.
WARNING
Avoid possible injury or death
Improper installation, adjustment, alteration, service or maintenance
can cause property damage, personal injury or loss of life. Refer to the
installation instructions and/or owner’s manual provided with this
appliance. A qualified installer, service agency or the gas supplier must
perform installation and service.
CRITICAL INSTALLATION WARNINGS
DO NOT install furnace on material that restricts return air, like
carpet or any soft material such as vinyl.
DO NOT install furnace where clearance to combustibles cannot be
maintained.
DO NOT modify furnace in any way.
DO NOT alter furnace for a positive grounding system.
DO NOT hi pot furnace unless electronic ignition system (circuit
board) has been disconnected.
DO NOT use a battery charger to supply power to a DC model
furnace even when testing.
DO NOT use 120-volt AC current with DC models.
DO NOT use furnace cabinet area as a storage compartment.
DO NOT vent furnace with venting system serving another
appliance.
DO NOT vent furnace to an outside enclosed porch area.
DO NOT use for temporary heating of buildings or structures under
construction.
Protect building materials from degrading from flue gas exhaust.
Protect furnace electrical components from water.
Compartment must be closed when operating unit.
Should the gas supply fail to shut off or if overheating occurs, shut
off the gas valve to the furnace before shutting off the electrical
supply.
DO NOT use this furnace if any part has been under water.
DO NOT use petroleum or citrus type cleaner on plastic parts, as
damage may occur.
CAUTION
PERSONAL INJURY
All sheet metal edges are sharp care should be taken when
handling or brushing up against them.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
WARNING
Be sure the furnace and all ignition systems are “off” during any type of
refueling and while vehicle is in motion or being towed.
SAFETY ALERT SYMBOLS
Safety Symbols alerting you to potential personal safety
hazards obey all safety messages following these
symbols
WARNING
Avoid possible injury or
death
CAUTION
Avoid possible injury
and/or property damage
WARNING
FIRE OR EXPLOSION
If the information in this manual is not followed
exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
FOR YOUR SAFETY
WHAT TO DO IF YOU SMELL GAS:
Extinguish any open flame.
Evacuate all persons from the vehicle.
Shut off the gas supply at the gas container
or source.
Do not touch any electrical switch, or use
any phone or radio in the vehicle.
Do not start the vehicle’s engine or electric
generator.
Contact the nearest gas supplier or qualified
service technician for repairs.
If you cannot reach a gas supplier or
qualified service technician, contact the
nearest fire department.
Do not turn on the gas supply until the gas
leak(s) have been repaired.
A qualified Service Technician
Service Center or gas supplier must perform
installation and service.
DOMETIC CORPORATION
1120 North Main Street
, E
lkhart
, IN 4651
4
Please Visit:
WWW.DOMETIC.COM
Revision A, 3/1
5/
19