www.dompneumatics.com
AIR IMPACT WRENCH TWIN HAMMER LONG ANVIL -
1/2”
SPECIFICATIONS
AIR SUPPLY
WARNING! Ensure the air supply is clean and does not exceed 90 psi while operating the Tool. Too high
an air pressure and unclean air will shorten the product life due to excessive wear and may be dangerous
causing damage and/or personal injury.
1. Ensure tool air trigger/lever
is in “off
” position before
connecting to the air supply.
2. You will require an air pressure of 90 psi and an air flow according to specification.
3. Drain the compressor air tank daily. Water in the air line will damage the tool.
4. Clean the compressor air inlet filter weekly.
5. Line pressure should be increased to compensate for unusually long air hoses (over 8 mts). The
minimum hose diameter should be 1/4” I.D and fittings mus
t have the same inside dimensions.
6. Keep hose away from heat, oil and sharp edges. Check hose for wear and make certain that all
connections are secure.
Model no
Free Speed
Square Drive
Air Consumption
Weight
Air Pressure
Air inlet
Overall Length
Max torque
Capacity
DIW
–
1/2
”
TLA
7,000 rpm
1/2”
4.2 cfm
2.6 kgs
90 psi
1/4”
bsp
198 mm
487 ft-lb (660 nm)
16 mm
