![background image](http://html1.mh-extra.com/html/dks/1815-350/1815-350_quick-start-manual_2512708001.webp)
LONG-RANGE TAG/CARD READER KIT
DoorKing Part Number
1815-350
The DoorKing UHF tag/card reader is designed as a long range RFID reader using passive tag/card technology. Passive tag/card technology does
not contain a battery in the tag/card so it will never wear out. The long range reader emits an RF signal which powers the tag/card when the
tag/card enters the scanning area of the reader’s antenna. The tag/card relays its Wiegand number back to the reader which reports the tag/card’s
number to the connected access control system. There is an interface module supplied with the reader that eliminates the need to set up the
system using a computer. All necessary settings and adjustments can be made using the DIP and rotary switch on the reader’s control board. It is
an effortless way to open the gate for authorized vehicles. Mount an authorized tag/card on the car that the antenna is able to scan and the gate will
open as the car approaches.
The system will work with 26-Bit wiegand controllers. It uses frequency-hopping technology in the 902-928 MHz band (standard).
The UHF long range reader can operate in two different modes:
Timing
and
Trigger
mode which are selectable using SW2, DIP-switch 1 on the
control board.
120 S. Glasgow Avenue
Inglewood, California 90301
U.S.A.
Modes of Operation
Timing Mode:
If DIP-switch SW2,
switch 1
is set to the “
OFF
” position (left), the reader will work in
Timing
mode. It
WILL
attempt
to read tag/cards that are within reading range at a rate determined by DIP-switch SW2, switches 2, 3 and 4. See other side for
Timing
mode wiring and DIP-switch settings.
Trigger Mode:
If DIP-switch SW2,
switch 1
is set to the “
ON
” position (right), the reader will work in
Trigger
mode. It
WILL NOT
attempt to read tag/cards
UNLESS
the two trigger signal wires are shorted together (car on loop). Connect the dry contact relay
wires of a vehicle loop detector to the loose red and black trigger wires on the long range antenna. See other side for “Optional”
Trigger
mode wiring and DIP-switch settings.
Installation
Side View
Make sure cars that have already passed
through the gate
will not
be in the scanning
area of the antenna.
See reverse side to properly adjust antenna
switches and scanning range.
ISO Card UHF P/N 1508-190
UHF/DK Prox Dual Technology Card P/N 1508-198
Card Windshield Holder P/N 1815-318
Rear View Mirror Card Holder P/N 1815-319
Headlight/Windshield Tag P/N 1508-195
License Plate Tag P/N 1508-199
Tags/Card Placement on Cars:
It should be placed on the side of the car
(headlight/windshield)
CLOSEST
to where the antenna is located. The tags/card
needs to be placed in
visual sight
of antenna or antenna can
NOT
read tags/card.
Never
place tags/card in a position that will block the drivers vision.
SW2
Antenna
Bracket
Included
Fits 1.5”-3”
post not
provided.
Accessories sold separately:
Illustrations not to scale
Antenna
scanning area
Antenna
scanning area
Top View
Point the
antenna
towards the
car waiting
to enter.
Weather
Resistant
Housing
Included
Roadway
In-Ground Loop (Optional) when using Trigger Mode
In-Ground Loop
(Optional)
when using
Trigger Mode
Tag/Card
Windshield
Placement
Possibility
Windshield
Tag/Card Placement Possibility.
Locate on side of car
closest
to antenna.
Headlight
Tag Placement Possibility.
Locate on side of car
closest
to antenna.
Antenna Placement (Either side of Roadway)
License Plate
ON
Mount Card/Tags
HORIZONTAL.
Mounting Tags/Card
vertically will
significantly
reduce scanning distance
and
NOT
recommended.
YES
Vertical
Position
Position the antenna in the same plane as the mounted tag/card.
- Windshield mounted tag/card: Slant mounted antenna works best.
- Headlight Tag/License Plate Tag: Vertically mounted antenna works best.
Antenna Plane
Slant mounted shown here.
Windshield Plane
(Slant)
Headlight Tag/
License Plate Tag
Plane
(Vertical)
Headlight/
Windshield
Tag
Headlight/
Windshield
Tag
License Plate Tag
License
Plate Tag
Card
Card
NO
Antenna
Placement
Possibility.
Antenna
Placement
Possibility.