M8 Softail
Floorboard Extensions
INSTRUCTIONS
(Please read entire sheet before beginning install)
Parts included:
4- Floorboard Extensions
4- 3/8-16 x 2 ¾” Grade 8 Socket head bolts
4- ⅜” low profile washers
1- ¼-20 ½” Set screw
Install Steps:
1. Start on the right side of the bike. Remove the two bolts holding the floorboard bracket
to the frame. Set the floorboard and bracket carefully aside.
2. Get the two Extensions included in the kit that are labeled R-F(Right Front) and R-B
(Right Back). along with two of the included bolts and washers. Place the bolts (with
washers) through the floorboard bracket.
3. Now place the R-F Extension on the bolt in the front mounting location with “R-F” facing
the bracket (the R-F marking will Not be up against the bike frame). Now do the same for
the R-B Extension on the rear bolt of the floorboard bracket, also with the R-B marking
up against the floorboard bracket.
4. Now put blue (medium) thread-locker on the two bolt threads.
5. Place the floorboard bracket with Extensions up against the bike frame and begin
threading the bolts into the frame. DO NOT be concerned about aligning the Extensions
at this time.
6. Just before the bolts are snug, twist the Extension for the best alignment. Then snug the
bolts down. Please NOTE- The HD bracket is a cast item and there are small variances
in shape from bike to bike, so shape alignment will rarely match the precisely CNC cut
Extensions.
7. Now torque them to 36-42 ft. lbs.
8. Before installing the left side, remove the front shift rod bolt that is going through the
heim joint. This will make installing the floorboard extensions easier. Set hardware
