H1
Cam Lock
H2
Cam Post
ATTENTION:
Unpack the unit and confirm all hardware are present. If any hardware required is missing, or if you have any
ques�ons regarding our products, please contact D2G customer service.
Assemble the unit on a carpeted floor or on a so� surface work area to avoid any scratch.
1. Insert 2 cam posts (H2) into holes in Panel C. Tighten only un�l
snug. Fit cam holes in the edge of Panel F over the cam posts. Insert
2 cam locks (H1) into cam lock holes on Panel F, use a phillips screw
driver to turn cam locks clockwise to secure cam posts. A�ached
the other Panel F to 2nd Panel C the same way.
2. Insert cam posts into holes in Panel B as shown below. The Middle Panel B has holes on two sides, insert cam posts into both sides.
Place Panel A, g, H and assembled Panel C as shown below. Star�ng from a Side Panel B by laying it on a flat surface, a�ach all joining
panels by fi�ng cam holes in the edges with corresponding cam posts. Insert cam locks into all cam lock holes in adjoining boards, then
�ghten all cam locks with a screw driver. Assemble the Middle Panel B and the remaining panels in the picture the same way.
NOTE:
A phillips screw driver is needed. 2 people recommended.
(a) (b) (c)
How to join 2 boards with CAM lock:
(a) Insert cam post into flat surface of a board. Fit the hole in the
edge of the joining board over the cam post.
(b) Each cam lock has an open sec�on at the back. Insert the cam
lock into the cam Be sure the opening fits the head of the cam post.
(c) Use a screw driver to turn the cam lock clockwise so it locks onto
the head of the cam post. Do not over �ghten.
PARTS
A Top Panel
B Side Panel
C Bo�om Panel
D Back Panel
F Toe Kick Panel
G Swing Door
g “THANK YOU” Flip Door
H Divider Panel
2pcs
3pcs
2pcs
1pc
2pcs
2pcs
2pcs
2pcs
HARDWARE
H1 Cam Lock
H2 Cam Post
H3 Wood Screw
H4 Concealed Hinge
52pcs
52pcs
24pcs
4pcs
ASSEMBLY INSTRUCTIONS
TRASH RECEPTACLE - “THANK YOU” DUAL
1 of 2
Ver. 03/18
