Installation Manual
❖Accessories
Bracket for machine
Electrical cable
⑤
Emergency cable
Air hose
④
Air regulator
Bolts
①for the bracket
②for the machine
③pass line adjusting
②
④Bonding
①
Mark tube, Terminal
③
Sticker
Air connector
⑤Apron plate
❖Method of Input
①
Power
Turn on "Power" switch
②
Set ⇔ Run
You can input a set value when "Set" lamp is lit.
Numeric value that can be changed item or number will be blink.
④
+/-
Using the switches, you can change the value.
If you need to continue inputting, repeat the ③, ④.
After setting
⑤
Set ⇔ Run
Sync
Sync
Feed
Release
Usually, the Release mode does not display.
Press the both switches of Sync Feed and
Sync Release switches, then the controller will
be able to receive the sync press cam signals.
Signal(Feed/Release), Scale for
pass line(on the bracket)
1-TS8-03, 2-NTS8-02
Only when changing settings item, the Release mode is supposed to display on the
"Feed Length" after displaying digit of lowest of "Feed Length"
③
← →
Using the switches, you can move the cursor position.
Push "Set ⇔ Run" switch, when "Run" lamp is lit, the setting
finishes.
⑥
Exclusive type
DIMAC
Model J06
8*5：6M
2-M12*30
Exclusive type
Description of good
J06
4-M8*15
1-M12*120
Net 4ml
Assortment
P6：8M
8M
Fixture for the air regulator
With air filter
2-M6*12
1
