M.2 NGFF/NVMe SSD
PCI EXPRESS ADD-ON CARD
Manual
DS-33172
Product Introduction
The M.2 NGFF/NVMe SSD PCI Express Add-On Card is a
cost-effective 10/100Mbps Fast Ethernet Card. With Auto-
Negotiation capability, the NIC automatically supports data
transmission bandwidth from 10Mbps to 100Mbps.
This function smoothly and automatically switches drivers
between 10Mbps and 100Mbps. The Network Interface Card
is your best choice to improve network performance with the
highest performance.
Specification
Compliant with PCI Express Specification Revision 3.0
Compliant with Serial ATA Specification Revision 3.0
Support NVMe key B/M m.2 SSD including 2230, 2242,
2260, 2280 and 22110 drives
Backwards compatible with PCIE V2.0 and V1.0
mainboards
Drive sizes are 110, 80, 60, 42 and 30mm
Support Any “M” Key M.2 SSD , “B” Key and “B+M” Key
M.2 SSD
B- Key interface can insert SSD of M.2 NGFF SATA
Protocol; then insert SATA cable to connect motherboard,
and use PCI E to supply power, without external power
supply
M-Key interface can insert SSD of M.2 NGFF PCI-E
Protocol, and PCI-E transmission data do not need to
access SATA cable to connect motherboard
The M.2 PCIe SSD gets its power supply form the
motherboard PCIe BUS slot 3.3v
Support operating system: Windows® 10, Windows® 8,
Windows® 8.1, Windows® Server 2012 R2, Linux, Fedora,
SUSE, Ubuntu, Red hat native drivers support PCIe NVMe
No driver is required because the driver is transparent to
the operating system
Package content
1 x PCIe x4 M.2 B&M Key NVMe SSD Adapter
1 x User’s Manual
1 x Low profile bracket
System Requirements
Windows® 10, Windows® 8, Windows® 8.1,
Windows® Server 2012 R2, Linux 32bit or 64 bit
One available PCI-Express x4/ x8/ x16 slot
Hardware installation
Please first install the M.2 M Key SSD and M.2 B Key
SSD into the NVMe adapter, and then follow these
steps:
1.
Turn Off the power to your computer.
2.
Unplug the power cord and remove your
computer’s cover.
3.
To install the card, carefully align the card’s bus
connector with the selected PCIe slot on the
motherboard. Push the board down firmly.
4.
Used the SATA cable connect NVMe adapter to the
motherboard SATA port
5.
Replace the slot bracket’s holding screw to secure
the card.
6.
Replace the computer cover and reconnect the
power cord.
Support:
If you have further questions, please contact our
customer support and you can find more information
on our homepage:
www.assmann.com
Declaration
Hereby Assmann Electronic GmbH declares that the
Declaration of Conformity is part of the shipping
content. If the Declaration of Conformity is missing,
you can request it by post under the below mentioned
manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
