background image

XP-300
Owner’s
Guide 

A Harman International Company

Visit Digitech on the World Wide Web at http://www.digitech.com

SAFETY HINTS:

WATER AND MOISTURE

: Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in

a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into
the enclosure through openings.

POWER SOURCES

: The appliance should be connected to a power supply only of the type described in the operating instructions

or as marked on the appliance.

GROUNDING OR POLARIZATION:

Precautions should be taken so that the grounding or polarization means of an appliance is

not defeated.

POWER CORD PROTECTION:

Power supply cords should be routed so that they are not likely to be walked on or pinched by

items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where
they exit from the appliance.

SERVICING: 

The user should not attempt to service the appliance beyond that described in the operating instructions. All other

servicing should be referred to qualified service personnel.

FUSING:

If your unit is equipped with a fuse receptacle, replace with only same type fuse. Refer to replacement text on the unit

for correct fuse type.

WARRANTY:

1. The warranty card must be mailed within ten days after purchase date to validate this warranty.

2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under

normal use and service.

3. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, pro-

vided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a

period of one year. A Return Authorization number may be obtained from DigiTech by telephone. The company shall not be

liable for any consequential damage as a result of the product’s use in any circuit or assembly.

4. Proof-of-purchase is considered to be the burden of the consumer.

5. DigiTech reserves the right to make changes in design or make additions to or improvements upon this product without incur-

ring any obligation to install the same on products previously manufactured.

6. The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor authorizes any person

to assume any obligation or liability in connection with the sale of this product. In no event shall DigiTech or its dealers be

liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond

their control.

Summary of Contents for XP300

Page 1: ...fer to replacement text on the unit for correct fuse type WARRANTY 1 The warranty card must be mailed within ten days after purchase date to validate this warranty 2 DigiTech warrants this product when used solely within the U S to be free from defects in materials and workmanship under normal use and service 3 DigiTech liability under this warranty is limited to repairing or replacing defective m...

Page 2: ...display will either read 1 40 Factory or U1 U6 User Note A complete listing of all Factory programs is located on the bottom panel of the XP 300 4 Program UP Hold DOWN Switch Lets you select programs Pressing once will move up through the program menu Press and hold and the XP 300 will move down through the program menu 5 BYPASS Hold TUNER Switch Puts the unit into Bypass by pressing the footswitc...

Page 3: ...k the pedal forward and press a foot switch The expression pedal is now calibrated If the pedal did not calibrate properly the display will read Er in which case you need to repeat this procedure again 12 AC Line Input Connect the power adpater here Use only the enclosed PS 750 power supply Tuner Mode To access the Tuner mode press and hold the BYPASS Hold TUNER footswitch until tu appears in the ...

Page 4: ...55020 1991 Supplementary Information The product herewith complies with the requirements of the Low Voltage Directive 73 23 EEC and the EMC Directive 89 336 EEC as amended by directive 93 68 EEC Digitech President of Digitech 8760 S Sandy Parkway Sandy Utah 84070 USA Effective 2 17 98 European Contact Your Local Digitech Sales and Service Office or International Sales Office 3 Overlook Drive 4 Amh...

Reviews: