![background image](http://html1.mh-extra.com/html/digicel/vm1510/vm1510_quick-start-manuals_2496898001.webp)
ENG_3
Front Panel
Power indicator ( )
The indicator light turns red when the power turns on.
Remote control signal sensor (
)
Do not block IR receiver, so that you can use the remote
CH
Channel Up/Down (up and down key)
VOL
Volume Up/Down (up and down key)
POWER
Switch the receiver power “ON” or “OFF”.
control properly.
Lock indicator ( )
Installation
QUICK START Guide
DIGICEL VM1510
Please read this installation guide carefully before you use this product and
ENG_1
2_ENG
Digicel is not responsible for problems caused by misuse of equipment.
Precaution
Place your product on a stable surface.
Do not drop or hit your product. This may cause a malfunction or injury.
Do not leave your product in too high or low temperature for a long time. Doing so may cause an explosion or an
electric shock.
Safety information
4_ENG
Installation
S/PDIF
HDMI
Connect a digital amplifer output.
Connect your decoder to an HDTV set with an HDMI cable
ETHERNET
Connect the LAN cable to Ethernet port.
USB
Connect the USB memory device to USB port
DC 12V IN
To connect your decoder to the main power supply.
LOOP OUT
Used to connect an antenna signal from the receiver
to either the antenna input jack on your television or
to another receiver.
CVBS
Video connection port to the TV or other equipment.
AUDIO
Audio connection port to the TV or other equipment.
ANT IN
DC 12V Power connection
Rear Panel
2_ENG
Digicel is not responsible for problems caused by misuse of equipment.
Precaution
Place your product on a stable surface.
Do not drop or hit your product. This may cause a malfunction or injury.
Do not leave your product in too high or low temperature for a long time. Doing so may cause an explosion or an
electric shock.
Safety information
2
3
1
4
5
6
7
9
8
1
2
3
4
5
6
FCC STATEMENT
Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment. Indoor use only.
3305-00550_MANUAL_DIGICEL_QUICK GUIDE_ENG_���.indd 1
2014-11-24 �� 1:29:06
This appliance and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter. A minimum separation
distance of 20
㎝
must be maintained between the antenna and the person for this appliance to satisfy the RF exposure requirements