background image

Detex Corporation,  302 Detex Drive,  New Braunfels,  Texas  78130-3045

(830)629-2900  /  1-800-729-3839  /  Fax (830)620-6711

E-MAIL: [email protected]               INTERNET: www.detex.com

101260 May 29, 2007

INSTALLATION INSTRUCTIONS FOR 03W ADVANTEX TRIM

DETEX INS-101260

TOOLS AND SUPPLIES

Safety Glasses

(Always put on safety glasses prior to beginning installation of unit)

Pencil

Center Punch

Hammer

Drill Motor

Drill Bits & Taps

Screw Driver (Phillips Drive)

Tape Measure

Summary of Contents for 03W ADVANTEX

Page 1: ...etex detex com INTERNET www detex com 101260 May 29 2007 INSTALLATION INSTRUCTIONS FOR 03W ADVANTEX TRIM DETEX INS 101260 TOOLS AND SUPPLIES Safety Glasses Always put on safety glasses prior to beginning installation of unit Pencil Center Punch Hammer Drill Motor Drill Bits Taps Screw Driver Phillips Drive Tape Measure ...

Page 2: ...ll pilot holes for remaining holes a through inside of door only 4 Using the backplate as a template on the outside door face align the two through holes Mark and center punch the two 2 remaining holes a 5 Note Verify that the slotted edge of the backplate faces the edge of the door Mark the outside trim cam hole d 6 Drill pilot holes a through outside of door only 7 Drill four 4 3 8 holes partway...

Page 3: ...nd drill a 1 1 2 hole Repeat for inside of door ASSEMBLING THE OUTSIDE TRIM AND BACKPLATE 1 Place the trim assembly against the door aligning the cylinder tailpiece through the backplate trim cam 2 Mark the tailpiece as it protrudes through the cam see Fig T2A 3 Remove trim assembly and cut the tailpiece just inside of the mark see Fig T2B Caution Tailpiece must not extend past the cam Page 3 ...

Page 4: ...backplate s trim cam on the inside door face 6 It may be necessary to hammer the sex nuts into the door face 7 Fasten the backplate to the inside door face with 1 4 20 machine screws provided Caution Do not overtighten 8 Key should turn freely in both counter clockwise and clockwise directions 9 Resume with panic hardware instruction 15 Fig T3 Page 4 ...

Reviews: