Part No. 912239 - 07-15-03
CL180FL FLASHLIGHT
This machine was designed for certain applications only.
Delta Machinery strongly recommends that this machine not be modified
and/or used for any application other than that for which it was designed. If
you have any questions relative to a particular application,
DO NOT
use the
machine until you have first contacted Delta to determine if it can or should
be performed on the product.
Technical Service Manager
Delta Machinery
4825 Highway 45 North
Jackson, TN 38305
(IN CANADA: 505 SOUTHGATE DRIVE, GUELPH, ONTARIO N1H 6M7)
1.
Do not use Model CL180FL Flashlight
with any battery pack other than
Delta Model CL180B.
2.
Do not operate Flashlights in explosive atmospheres, such as in the
presence of flammable liquids, gases, or dust.
Flashlights can create
internal sparks which may ignite the dust or fumes.
3.
Bulbs and lenses get hot during use.
Do not touch the lens or the bulb
during or immediately after use. Exercise care when operating the flash-
light near flammable material. After use, allow the flashlight to cool before
placing it near any flammable material, or before servicing.
4.
Do not look directly
into the beam of light.
5.
Dispose of expended batteries properly.
The
Delta Battery Packs contain rechargeable, nickel-
cadmium batteries. These batteries must be recy-
cled or disposed of properly. Drop off expend-ed
battery packs at your local replacement battery
retailer, your local recycling center, or at a Delta
Service Center. Applicable fees for the collection
and recycling of these batteries (in the United
States) have been paid to the RBRC
™
. For further
information, call: 1-800-8-BATTERY.
RBRC™ is a Trademark of
the Rechargeable Battery
Recycling Corporation.
SAFETY RULES FOR FLASHLIGHTS
INSTALLING OR REMOVING BATTERY PACK
TO INSTALL BATTERY PACK:
Align
rails (A) Fig. 1, on battery pack with
slots on tool and push battery pack
onto tool until it locks in place.
TO REMOVE BATTERY PACK:
Depress the battery release button
(B) Fig. 1, and pull battery pack out of
tool.
Fig. 1
A
B
