background image

 

Dell E151FP Color Display Quick Setup Guide 

 

Dell™ E151FP Color Display 

 

Quick Setup Guide 

  

Safety 

Instructions

 

Observe the following safety guidelines when connecting and using your display: 

• 

Be sure that your display is electrically rated to operate with the AC power available in your location. 

• 

Locate your display near an easily accessible electrical outlet. 

• 

Place the display on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply 
hit, or touched with a sharp or abrasive implement. 

• 

Put your display in a location with low humidity and a minimum of dust.  

• 

Never use your display if the power cable has been damaged. Do not allow anything to rest on the power 
cable, and keep the cable away from where people could trip over it. 

• 

Never insert anything metallic into the display openings. Doing so may create the danger of electric shock. 

• 

To avoid electric shock, never touch the inside of the display. Only a qualified technician should open the 
display’s case. 

• 

Be sure to hold the plug, not the cable, when disconnecting the display from an electrical outlet. 

• 

Openings in the display cabinet are provided for ventilation. To prevent overheating, these openings 
should not be blocked or covered. Also, avoid using the display on a bed, sofa, rug, or other soft surface. 
Doing so may block the ventilation openings in the bottom of the cabinet. If you put the display in a 
bookcase or some other enclosed space, be sure to provide adequate ventilation. 

• 

Do not expose the display to rain or use it near water. If the display accidentally gets wet, unplug it and 
contact an authorized dealer immediately. You can clean the exterior of the display with a damp cloth 
when necessary, but be sure to unplug the display first. 

• 

If your display does not operate normally—in particular, if there are any unusual sounds or smells coming 
from it—unplug the display immediately and contact an authorized dealer or service center. 

   

Connecting Your Display to a Computer 

(A)  Make sure that the computer and monitor’s power are both turned off. Please follow the steps to install 

your LCD monitor. 

 

 

 
 
 
Step 1. Pull the base out. 

 

 
 
 
Step 2. Connect the power cord to your 
LCD monitor. 

 

 
Step 3. Connect the VGA-Cable 
that is directly attached to the 
monitor, to the VGA output of the 
graphics card on the computer.   

 
(B)  Connect the power cord at the back of the monitor to an AC power socket. Please make sure that the 

socket is not blocked or covered, so you can disconnect the unit from AC supply if you need to. Your 
monitor is equipped with an automatic power supply for a voltage range from 100 to 240 Volt at a 
frequency of 50 to 60 Hz. Be sure that your local power is within the supported range. If you are unsure, 
ask your electricity supplier. 

 
(C)  Turn on your computer and display. If the display does not display an image, refer to the troubleshooting 

section of this guide. 

 

 

 

Summary of Contents for E151FP

Page 1: ...enings in the bottom of the cabinet If you put the display in a bookcase or some other enclosed space be sure to provide adequate ventilation Do not expose the display to rain or use it near water If the display accidentally gets wet unplug it and contact an authorized dealer immediately You can clean the exterior of the display with a damp cloth when necessary but be sure to unplug the display fi...

Page 2: ...pdate the driver perform the following steps 1 Click StartÆ SettingsÆ Control Panel and then double click Display 2 In the Display Properties window click the Settings tab and then click Advanced 3 Click the Monitor tab and then click ChangeÆ Specify the location of the driverÆNext 4 When the Update Device Driver Wizard dialog box appears select Display a list of all the drivers in a specific loca...

Page 3: ...Internet access you can access the guide on the display CD 1 Insert the display CD into your CD ROM drive A start up document should launch automatically however if the start up document does not launch automatically click StartÆ Run type D monitor htm and click OK Substitute the correct CD ROM drive letter if it is not the D drive 2 Click the appropriate icon to open the User s Guide in the desir...

Page 4: ...rporation All rights reserved Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden Trademarks used in this text Dell and the DELL logo are trademarks of Dell Computer Corporation Microsoft and Windows are registered trademarks of Microsoft Corporation Other trademarks and trade names may be used in this document to refer to either ...

Reviews: