![background image](http://html1.mh-extra.com/html/decora/sunwood/sunwood_fitting-instructions_2462106001.webp)
Sunwood 50mm Basswood- Solid Timber Venetian Blinds
A.
Brackets should be placed at the
width of blinds headrail 6mm past each
end. The bracket doesn’t necessarily
need to touch the inside face of the
window frame.
B.
Align the top of the centre support
bracket with the top of the mounting
bracket before installation. Install with
the bigger flap of the centre support
bracket on the top side and clear of the
slat ladder positions.
C.
Push rail into brackets. Then press
gate to close brackets.
D.
Screw valance clips onto back side
of the valance with screws provided
(Screw #3)
E. For Outside Mount:
Screw one
end of the valance return clip onto the
valance using Screw #3. Align the edge
of the valance return with the valance.
Screw the other end of the valance clip
onto the valance return.
F.
Hook valance clip with valance
attached onto the top of the headrail.
G.
Always tilt blind horizontally before
raising/lowering to extend the life of
the blind.
To lower blind
: Move
cord to left pulling down gently until
cord lock releases.
To raise blind:
Pull
cord downward until blind reaches
desired height.
To lock cords:
Pull
cord right and release. Cord will lock
automatically.
Installing Hold Down Brackets
(Optional)
H. Hold down brackets:
Using two
small screws, screw hold down bracket
to window facing or wall.
Snap bracket pin ends into the hole at
bottom rail end.
(
Note:
Centre support supplied for blind width 100cm or over)
WARNING
Children can be strangled in blind or drapery cords. To
keep cords out of reach of children, use these methods:
1. Clamp
2. Cleat
3. Tie the cord to itself
4. Tie-down device
Young children can strangle in the loop of
pull cords, chains, tapes that operate window
coverings. They can also wrap the cords around
their necks. To avoid the risk of strangulation
and entanglement, keep cords out of the
reach of young children. Move beds, cots and
furniture away from window covering cords.
child
safe
Metal tape
measure
Mounting
Bracket
Screw #1
Screw #2
Screw #3
Valance Clip
Valance Return
Clip
Cord Cleat
Cord Cleat
Screw
Hold Down
Bracket
Centre Support
Pencil
Drill
Philips Head
Screwdriver
Step
Ladder
Drill Bit
(1/8" diameter)
WARNING
TOOLS RECOMMENDED FOR INSTALLATION
:
MOUNTING HARDWARE
MOUNTING INSTRUCTIONS
A
B
C
D
E
F
G
H
Headrail
Headrail
Gate
Outside Mount
Ceiling Mount
Inside Mount
Screw #1
Screw #3
Screw #3
Screw #3
Screw #2
Mounting Bracket
Mounting Bracket
Valance Clip
Valance
Valance
Valance
Return
Clip
Valance with Clip attached
Bottom
rail
Valance Return
Centre Support
Mounting
Bracket
Headrail
Tilt
Cord
Pull Cord