Days
®
MRI Wheelchair
7102061
Carton contains the Days MRI Wheelchair,
(2) Legrests, (1) Push Bar, and (1) Repair Kit.
Wheelchair weight capacity: 220 lbs.
Figure 1.
Chair arrives folded. Legrests and Push
Bar are not attached.
Figure 2. UNFOLD THE MAIN BODY
•
Press downward on the top of the Seat
Supports until the wheelchair is fully opened
and the seat rails are fully extended.
•
DO NOT
press on the arm rests. Doing so will
result in damage to the wheelchair.
Figures 3 & 4. ATTACH LEGRESTS
•
Make sure Legrest Toggle on each Legrest is
in the up position.
•
Line up the Legrest Channel on the Legrest
with the Legrest Track on the wheelchair.
•
Slide Legrest downward onto Legrest Track
to desired position, then push down Legrest
Toggle to lock Legrest into place.
Repair Kit
A. (2) Bearing
(for repair if original breaks)
B. (5) Back Wheel Dust Cover
(replacement part)
C. (2) Lock Nut
(replacement part)
D. (2) Lock Nut Cap
(replacement part)
E. (1) Spanner
(tool for tightening or undoing all plastic
nuts on chair)
D
E
A
C
B
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Push Bar
Lock Nut
Lock Nut
Leg Rests
Figure 5. WITH LEGRESTS ATTACHED
(Before Push Bar is attached)
Figure 6. ATTACH PUSH BAR
•
Loosen Lock Nuts on both sides of Push Bar.
•
Line up ends of Push Bar with handles on
both sides of back of wheelchair.
•
Insert Push Bar fully then twist and tighten
Lock Nuts to ensure Push Bar is securely
attached.
TO FOLD WHEELCHAIR
•
Place Foot Plates on the Legrests into the
upright vertical position.
•
Loosen Lock Nuts and remove Push Handle.
•
Pull up on side Seat Supports.
Designed for non-ferrous detection systems
through Tesla 7. Tesla Compatibility: 1.5, 3 and 7*
*Tesla (T) is the unit of measurement quantifying the strength of a magnetic
field. Prior to the 3 Tesla Machine, the high-field standard was 1.5 Tesla. 7
Tesla is a new FDA approved innovation.
Figure 1
Foot Plates
Legrest
Channel
Legrest
Track
Legrest
Toggle
Seat
Supports
