Daktronics PPX-1001 Series, Quick Manual

Page: 1 / 4

PPX-1001 Series Panel Installation & Service Quick Guide Page 1 of 4
DD4935634
Rev 01
08 December 2021 201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
Basics
Display Accessories
Standard display accessories include the following:
• Power input cable
• Power jumper cable
• Signal input cable
• Signal jumper cable
Figure 1: Power Input Cable Figure 2: Power Jumper Cable
Figure 3: Signal Input Cable
Figure 4: Signal Jumper Cable
Storage & Shipping
Panels are stored and shipped in flight cases. Refer to Figure 5 , Figure 6,
and Figure 7 for dimensions.
Figure 5: Flight Case (Front View)
275 mm
765 mm
1150 mm
Figure 6: Flight Case (Side View)
730 mm
1190 mm
730 mm
1050 mm
100 mm
960 mm
155 mm
20 mm
Figure 7: Flight Case (Top View)
Wheels nest in the top of the flight
case below when cases are stacked.
Refer to Figure 8 . Cases can be
stacked two- or three-high as shown
in Figure 9 .
Figure 8: Nested Wheels
Mechanical Installation
Panel Installation
Note: Two people are required for the steps in this section.
1. Disengage the latches securing the top of the flight case and remove
the top. Refer to Figure 10 .
Figure 10: Remove Flight Case Top Figure 11: Remove Locking Pins
2. Use the side handles on the panel to remove the panel from the case.
Figure 9: Stacked Flight Cases
3. Use the side handles on the panel to hold the panel upright and then
remove the locking pin from each leg of the foot structure. Refer to
Figure 11 .
4. Unfold each leg of the foot structure downward and extend the
stiffeners. Refer to Figure 12 and Figure 13 .
Figure 12: Unfold Legs Figure 13: Extend Stiffeners
5. Slide the toes outward to stabilize the panel. Refer to Figure 14 .
Figure 14: Slide Toes Outward Figure 15: Adjust Angle of Panel
6. Adjust the angle of the panel if desired. Remove the locking pin from
each leg of the foot structure and adjust the position of the stiffeners
within the brackets. The bottom bracket adjusts the panel to 90°, and
each slot provides an additional 5° of adjustment. When the panel is
set at the desired angle, ensure the stiffeners remain in position within
the brackets and replace the locking pins. Refer to Figure 15 .
7. Repeat Steps 3-7 for any additional panels.